Nonlinear dynamic tests of a reinforced concrete frame building at different damage levels

Abstract

This paper discusses the dynamic tests of a two-story infilled reinforced concrete (RC) frame building using an eccentric-mass shaker. The building, located in El Centro, CA, was substantially damaged prior to the tests due to the seismic activity in the area. During the testing sequence, five infill walls were removed to introduce additional damage states and to investigate the changes in the dynamic properties and the nonlinear response of the building to the induced excitations. The accelerations and displacements of the structure under the forced and ambient vibrations were recorded through an array of sensors, while lidar scans were obtained to document the damage. The test data provide insight into the nonlinear response of an actual building and the change of its resonant frequencies and operational shapes due to varying damage levels and changes of the excitation amplitude, frequency, and orientation. K E Y W O R D Sdynamic testing, nonlinear response, reinforced concrete building, structural irregularities, system identification

Vibration-Based Tests and Results for the Evaluation of Infill Masonry Walls Influence on the Dynamic Behaviour of Buildings: A Review

“…A similar experimental campaign has been performed by Moaveni et al [95]: they tested a 2/3-scaled three-storey infilled RC frame built on a shaking table following design prescriptions of past codes, and they achieved very similar outcomes. Yousefianmoghadam et al [96,97] tested two real infilled RC frame buildings (with two and ten stories) with FVs (shaker), free vibrations and AVTs considering different damage levels of the infills; in detail, the damage was simulated removing progressively some infills throughout the building. They found a progressively decrease in frequencies after the infill damage, together with a frequency decrease with the increasing input excitation level (in terms of acceleration amplitudes), i.e., the frequencies identified from AVT recordings were higher than those identified from FV and free vibration measurements.…”

Accounting for Modeling Errors and Inherent Structural Variability through a Hierarchical Bayesian Model Updating Approach: An Overview

“…The third application is a two-story RC building located in El Centro, California, shown in Figure 13 a [ 6 , 56 , 69 , 70 ]. The building was severely damaged by past earthquakes and left uninhabited, which provided an opportunity to perform wall removals and destructive shaking tests on this full-scale RC building.…”

Simulation analysis of structural nonlinear seismic response

“…Currently, there have been a large number of numerical simulations and model experiments. However, whether it can accurately grasp its true stress state and stress environment, whether it can be ignored in engineering design, whether it can ignore certain stress states and failure forms, and whether it can bring potential safety risks are important issues that urgently need to be solved [1][2][3]. During service, structural damage and even sudden accidents can occur due to fatigue, corrosion, material aging, and seismic effects.…”