Nonconventional Partial Discharge Measurement using Fiber Optic Sensor System for Transmission Systems And Switchgear

Gräf, Thomas; Menge, Matthias; Kolling, Moritz; Zamzow, Thomas; Heidmann, Gerd; Vaterrodt, K.

doi:10.1109/diagnostika49114.2020.9214727

Cited by 2 publications

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In 2024, the Chenxi Li team designed a fiber-optic acoustic sensing system used for vibration and voice monitoring and an acquisition system sampling rate up to 20 kHz [19]. Due to the rapid development of optical fiber sensors in recent years, the application of optical fibers as a signal sensor for partial discharge signal measurement has gradually entered the field of scientific research [20]. However, there is still a gap in the low-cost acquisition board for optical fiber signals, such as high-speed vibration signals like partial discharges.…”

Section: Introductionmentioning

confidence: 99%

Hardware and Software Design of Programmable Medium and High-Speed Data Acquisition (DAQ) Board of Fiber Optic Signal for Partial Discharge Acquisition

Tong,

Zhang,

Zhang

2024

Electronics

View full text Add to dashboard Cite

The anti-electromagnetic interference capability of partial discharge (PD) acoustic signal conversion and collection circuits severely restrict the sensitivity of PD detection. The data acquisition (DAQ) systems available in the current market are costly and have limited functionality, making it difficult to satisfy the acquisition requirements for PD detection. This paper proposes a medium to high-speed fiber optic signal acquisition board with an adjustably controlled sampling rate and filter cutoff frequency. The circuit achieves a higher signal-to-noise (SNR) ratio by distributing the noise in each part of the signal acquisition chain reasonably. The temperature characteristics of the acquisition module are improved by utilizing the programmable T-type structure for transimpedance amplification of photocurrent. The DAQ card performs data acquisition and processing using STM32H743 internal ADC and caches data in bulk with an SRAM and SD card. A data uploading method based on time reference has been proposed, which enables full, effective information signal upload through a low-cost transmission interface. The research ultimately achieves a stable sampling of three channels at 1 MSps, SNR of 63 dB, and programmable gain amplification of the photocurrent with 0–60 dB. Finally, the system is used for PD acoustic signal acquisition in the frequency range of 20 Hz to 100 kHz.

show abstract

Section: Introductionmentioning

confidence: 99%