New mud for UnderBalanced Drilling

Wysocki, Sławomir; Gaczoł, Magdalena; Wysocka, M.

doi:10.7494/drill.2016.33.4.801

Cited by 1 publication

(1 citation statement)

References 5 publications

(3 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Among the many advantages of the method, the following are highlighted: the possibility of maximum rock penetration, longer life span of the drill bit, and maintaining cleanliness of the borehole, which is connected to better control of all processes occurring during drilling [44]. As for the need to constantly decrease the impact of drilling on the environment and the need to acquire samples for further research, cleanliness is a significant advantage of the air method in comparison to other methods, both in terms of the method itself (generally a "cleaner" one) and the output (which is less contaminated) [45,46].…”

Section: Introductionmentioning

confidence: 99%

Influence of Rotation Speed and Air Pressure on the Down the Hole Drilling Velocity for Borehole Heat Exchanger Installation

et al. 2020

View full text Add to dashboard Cite

The relation between rotation speed, air pressure and the velocity of air-rotary drilling using the down the hole method is determined in an empirical manner. For the study, velocity measurements are obtained for combinations of the aforementioned parameters during fieldwork for the installation of borehole heat exchangers near Lublin, Poland. The tests consider three drill bit diameters—110, 127 and 140 mm; three rotational speeds—20, 40 and 60 1/min; and three air pressures—16, 20 and 24 bar. The borehole heat exchangers need 100 m deep wells. The lithology consists mainly of loess and clays to 24 m, sand and carbonate rocks to 36 m, and marls and limestone to 100 m. It is found that the highest drilling velocity is achieved when the greatest pressure is applied, while the lowest drilling velocity is connected to the lowest pressure. However, the relation between rotation speed and drilling velocity is more complex, as drilling velocity seems to be more affected by depth. Therefore, lithology can be a major factor. The results may find direct use in drilling, and provide a basis for further studies on the optimization of drilling technology.

show abstract

Section: Introductionmentioning

confidence: 99%