Neutron irradiation and temperature effects on induced voltages in various mineral insulated cables and ceramic-coated wires

Vermeeren, L.

doi:10.1016/j.fusengdes.2010.12.047

Cited by 2 publications

(1 citation statement)

References 8 publications

(18 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…For ITER, implementing for example targeting systems for laser alignment requires careful selection of fibres and quadrature detectors and the avoidance of cameras. For actuators, piezoelectric systems [3,6] have some margin and radiation hard motors can be wound with special glass or ceramic-insulated cabling [39] and special bearings. Nonetheless, some failures could still occur in long (over 40 years) reactor lifetime.…”

Section: Jinst 19 C04013mentioning

confidence: 99%

Laser and microwave instrumentation for ITER and future reactors

Vayakis

2024

J. Inst.

View full text Add to dashboard Cite

ITER diagnostics include an extensive set of laser and microwave diagnostics to give access to a wealth of information on the core and edge plasma and to support high performance operation of ITER. For example, Core and Edge Thomson scattering systems build detailed density and temperature profiles on time scales much faster than τ E to follow transient events; ECE and reflectometry add time resolution to follow MHD events. Implementing these diagnostics is challenging, needing a panoply of technologies to keep them functioning reliably for thousands of hours despite extreme events such as disruptions and wall conditioning cycles. Shielding, shutters and cleaning systems protect the forward elements of most optical systems from the build-up of deposits and damage. Still, plasma-facing mirrors must survive laser loads and endure erosion, deposition and in-situ RF cleaning. Calibration and monitoring systems ensure accurate and drift-free operation. These support systems are also not straightforward and required specific R&D. Access also drives the design: to deal with the neutron and gamma sources yet allow maintenance of activated components, ITER uses large, multi-purpose ports that couple otherwise distinct systems into modules for maintenance. Machine movement requires provisions to maintain alignment and calibration, from these port plugs, shown in figure 1, to the accessible areas 10–50 m away. A final complication comes from the difficulty of employing electronics near the plugs. Extensive qualification for radiation resistance is needed. This paper examines design adaptations that ITER adopted for its near-reactor environment, consider the lessons learnt from the ITER design activity specifically for laser and microwave systems and lays out some possible evolution paths for the reactor diagnostician that must follow a more industrial approach.

show abstract

Section: Jinst 19 C04013mentioning

confidence: 99%