Network-Assistance to Improve Joint 5G and GNSS Positioning for GNSS Anti-Spoofing

Dietmayer, Katrin; Duong, Phuong Bich; Merwe, J. Rossouw van der; Ghimire, Birendra; Seitz, Jochen

doi:10.33012/2022.18435

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Limiting how often data are sent could minimize these costs. Another approach is integrating the GNSS monitoring into a mobile network, such as 5G, as this could create a beneficial interdependency between the network and the monitoring stations [ 91 ].…”

Section: Hardware Designmentioning

confidence: 99%

Low-Cost COTS GNSS Interference Monitoring, Detection, and Classification System

Merwe

Franco

Hansen

et al. 2023

Sensors

View full text Add to dashboard Cite

Interference signals cause position errors and outages to global navigation satellite system (GNSS) receivers. However, to solve these problems, the interference source must be detected, classified, its purpose determined, and localized to eliminate it. Several interference monitoring solutions exist, but these are expensive, resulting in fewer nodes that may miss spatially sparse interference signals. This article introduces a low-cost commercial-off-the-shelf (COTS) GNSS interference monitoring, detection, and classification receiver. It employs machine learning (ML) on tailored signal pre-processing of the raw signal samples and GNSS measurements to facilitate a generalized, high-performance architecture that does not require human-in-the-loop (HIL) calibration. Therefore, the low-cost receivers with high performance can justify significantly more receivers being deployed, resulting in a significantly higher probability of intercept (POI). The architecture of the monitoring system is described in detail in this article, including an analysis of the energy consumption and optimization. Controlled interference scenarios demonstrate detection and classification capabilities exceeding conventional approaches. The ML results show that accurate and reliable detection and classification are possible with COTS hardware.

show abstract

Section: Hardware Designmentioning

confidence: 99%