Nanocomposite-Based Electrode Structures for EEG Signal Acquisition

Abstract

Objective: To fabricate a lightweight, breathable, comfortable, and able to contour to the curvilinear body shape, electrodes built on a flexible substrate are a significant growth in wearable health monitoring. This research aims to create a GNP/FE electrode-based EEG signal acquisition system that is both efficient and inexpensive. Methodology: Three distinct electrode concentrations were developed for EEG signal acquisition, three distinct electrode concentrations (1.5:1.5, 2:1, and 3:0). The high strength-to-weight ratio to form the tribofilm in the fabrication of the electrode will provide good efficiency. The EEG signal is first subjected to a wavelet transform, which serves as a preliminary analysis. The use of biopotential signals in wearable systems as biofeedback or control commands is expected to substantially impact point-of-care health monitoring systems, rehabilitation devices, human–computer/machine interfaces (HCI/HMI), and brain–computer interfaces (BCIs). The graphene oxide (GO), glycerol (GL), and polyvinyl alcohol (PVA) GO/GL/PVA plastic electrodes were measured and compared to that of a commercially available electrode using the biopic equipment. The GO/GL/PVA plastic electrode was able to detect EEG signals satisfactorily after being used for two months, demonstrating good conductivity and lower noise than the commercial electrode. The GO/GL/PVA nanocomposite mixture was put into the electrode mold as soon as it was ready and then rapidly chilled. Results: The quality of an acquired EEG signal could be measured in several ways including by its error percentage, correlation coefficient, and signal-to-noise ratio (SNR). The fabricated electrode yield detection ranged from 0.81 kPa−1 % to 34.90 kPa−1%. The performance was estimated up to the response of 54 ms. Linear heating at the rate of 40 °C per minute was implemented on the sample ranges from 0 °C to 240 °C. During the sample electrode testing in EEG signal analysis, it obtained low impedance with a good quality of signal acquisition when compared to a conventional wet type of electrode. Conclusions: A large database was frequently built from all of the simulated signals in MATLAB code. Through the experiment, all of the required data were collected, checked against all other signals, and proven that they were accurate representations of the intended database. Evidence suggests that graphene nanoplatelets (GNP) hematite (FE2O3) polyvinylidene fluoride (PVDF) GNP/FE2O3@PVDF electrodes with a 3:0 concentration yielded the best outcomes.

Evaluation of Strategies Based on Wavelet-ICA and ICLabel for Artifact Correction in EEG Recordings

“…Among the commonly used preprocessing stages that allow the researcher to achieve an optimal signal-to-noise ratio are line noise removal, the detection and interpolation of bad channels, epoch segmentation to ensure the assumption of quasi-stationarity, the elimination of defective EEG epochs, and the removal of physiological artifacts (Bigdely-Shamlo et al, 2015;Kim et al, 2019;Suárez-Revelo et al, 2016). Different studies show that preprocessing EEG signals has a big impact on the final results (Vajravelu et al, 2021;Pedroni et al, 2019). Therefore, it is necessary to find ways to identify and separate the different sources of noise in order to obtain a clean EEG signal for subsequent analyses (Jiang et al, 2019;Kaur et al, 2020).…”