Multiwalled carbon nanotube/polysulfone composites: Using the Hildebrand solubility parameter to predict dispersion

Abstract

Polysulfone composites were prepared by solution casting, using various types of treated carbon nanotubes (CNTs) at loadings of up to 5 wt%. The CNT types tested were: as‐received, acid treated, OCA surfactant, OCA functionalized and Poly(methyl methacrylate) functionalized nanotubes prepared using both as‐received and acid treated CNT. The treatment types investigated were selected based upon their solubility parameters and on the results of previous studies. The treated CNTs, CNT/solvent dispersions and the final composite samples were characterised using Fourier Transform Infrared Spectroscopy (FTIR), thermal analysis, Transmission Electron Microscopy (TEM), Ultraviolet‐Visible (UV‐vis) spectroscopy, optical microscopy, electrical conductivity and tensile testing. It was observed that the all the treatments studied improved the stability of CNT in the solvent. Of the CNT types studied, composites containing OCA functionalised CNT displayed the lowest percolation threshold (3 wt%) and highest mechanical performance. While the use of Hildebrand solubility parameters is useful in indentifying promising CNT treatments, their use can not fully predict CNT dispersion behaviour and composite performance. It is also critical to consider the influence of any treatments on CNT length and residual solvent levels. POLYM. COMPOS., 2011. © 2011 Society of Plastics Engineers

Influence of matching solubility parameter of polymer matrix and CNT on electrical conductivity of CNT/rubber composite

“…An apt example is dispersion of HiPCO-SWCNTs into NMP ( N -methylpyrrolidone), where the solubility parameters were experimentally determined as 20.8 MPa 1/2 and 23.0 MPa 1/2 , respectively to form a spontaneous dispersion of HiPCO-SWCNT. Furthermore, Dixon et al, reported that matching solubility parameter is important to achieve lower percolation threshold and higher mechanical property 18 .…”

Miscibility, Glass Transition Temperature and Mechanical Properties of NC/DBP Binary Systems by Molecular Dynamics

“…Accordingly, the miscibility between polymer and plasticizer should be studied first. Solubility parameter (d) has been widely used for investigating physical compatibility of materials [19][20][21][22]. d, as defined by Hildebrand and Scott [23], is the square root of the cohesive energy density (CED) which refers to the energy required to vaporize a mole of liquid per unit volume and is mathematically defined by the following equation [23,24]:…”

Comparison of the performance of reduced graphene oxide and multiwalled carbon nanotubes based sulfonated polysulfone membranes for electrolysis application

“…Finally, the nonpolar nature of CNTs leads to their weak bonding to the polymer matrix which limits their load transfer . However, both experimentally and theoretically, it is observed that percolation threshold decreases significantly as the aspect ratio of filler CNTs increases . CNTs also suffer from nonuniformities originated in the diversity of the diameter of the individual nanotubes which could dramatically influence surface areas and, therefore, the conductivity .…”