Multiferroic Properties of Nanopowder‐Synthesized Ferroelectric‐Ferromagnetic 0.6BaTiO3‐0.4NiFe2O4 Ceramic

Xu, Xiaojun; Wu, Zheng; Yao, Jia; Li, Weijian; Liu, Yongsheng; Zhang, Yihe; Xue, A’Xi

doi:10.1155/2015/613565

Cited by 8 publications

(1 citation statement)

References 17 publications

(19 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Such peaks were attributed to the (100), (101), (111), (200), (201), (211), (202), (212), (310) and (113) crystal planes, respectively. These observations are consistent with previous studies [ 30 , 36 ].…”

Section: Resultssupporting

confidence: 94%

BaTiO3 Functional Perovskite as Photocathode in Microbial Fuel Cells for Energy Production and Wastewater Treatment

et al. 2023

View full text Add to dashboard Cite

Microbial fuel cells (MFCs) provide new opportunities for the sustainable production of energy, converting organic matter into electricity through microorganisms. Moreover, MFCs play an important role in remediation of environmental pollutants from wastewater with power generation. This work focuses on the evaluation of ferroelectric perovskite materials as a new class of non-precious photocatalysts for MFC cathode construction. Nanoparticles of BaTiO3 (BT) were prepared and tested in a microbial fuel cell (MFC) as photocathode catalytic components. The catalyst phases were synthesized, identified and characterized by XRD, SEM, UV–Vis absorption spectroscopy, P-E hysteresis and dielectric measurements. The maximum absorption of BT nanoparticles was recorded at 285 nm and the energy gap (Eg) was estimated to be 3.77 eV. Photocatalytic performance of cathodes coated with BaTiO3 was measured in a dark environment and then in the presence of a UV–visible (UV–Vis) light source, using a mixture of dairy industry and domestic wastewater as a feedstock for the MFCs. The performance of the BT cathodic component is strongly dependent on the presence of UV–Vis irradiation. The BT-based cathode functioning under UV–visible light improves the maximum power densities and the open circuit voltage (OCV) of the MFC system. The values increased from 64 mW m−2 to 498 mW m−2 and from 280 mV to 387 mV, respectively, showing that the presence of light effectively improved the photocatalytic activity of this ceramic. Furthermore, the MFCs operating under optimal conditions were able to reduce the chemical oxygen demand load in wastewater by 90% (initial COD = 2500 mg L−1).

show abstract

Section: Resultssupporting

confidence: 94%