Mounting Rail Spacers for Improved Solar Panel Durability

Gabor, Andrew M.; Janoch, Rob; Anselmo, Andrew; Lincoln, Jason; Schneller, Eric; Seigneur, Hubert; Harwood, Duncan J.; Rowell, Michael W.

doi:10.1109/pvsc40753.2019.8981256

Cited by 2 publications

(1 citation statement)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Improper techniques during fabrication like inaccurate handling of solar cells during the series/parallel combination of the cells or during the lamination process, can give rise to micro cracks in the cells which are not visible to naked eye but may become the reason of drop in performance of the modules. Moreover, thermal stresses are also generated in the solar cells during the soldering process due to difference in the coefficient of thermal expansion of the silicon and metallic parts, which can act as sites for micro crack initiation during their field operations due to wind load 10,22‐24 . Studies have been conducted to analyze stresses in wafers during the manufacturing cycle where the wafers are subjected to mechanical loads such as sawing and manual handling 25 .…”

Section: Introductionmentioning

confidence: 99%

The impact of static wind load on the mechanical integrity of different commercially available mono‐crystalline photovoltaic modules

Gul

Kamran

Zafar

et al. 2020

Engineering Reports

View full text Add to dashboard Cite

Mechanical integrity of Photovoltaic (PV) modules, which is dependent upon the materials used and the manufacturing process, plays an important role in their performance and electrical output. Besides, the mechanical integrity of the modules is also affected by environmental conditions. Mechanical loads, which include loads produced by wind, snow, rain, and hail, tend to degrade the performance of the PV module by generating stresses and enhancing micro cracks and defects. This research aims to investigate the impact of wind loads on the performance degradation of PV modules. The overall objective was to investigate the reliability of modules available in Pakistan. Wind loads were simulated through an indigenously developed setup which allowed application of uniform load of 2400 Pa on the modules as per international standards (IEC 61215 and ASTM E1830-15). A total of 12 PV modules, from three different vendors, each of 50 W rated power, were subjected to solar flash testing and electroluminescence imaging before and after the application of three cycles of mechanical load test. Greatest effect of wind loads was observed for modules which had defects present prior to the application of load. A maximum drop of 3.19% in the power output and 8.24% increase in the series resistance was observed. The results highlight that wind load has the ability to initiate cracks, propagate the pre-existing ones as well as damage the grid fingers. K E Y W O R D S degradation, electrical efficiency, mechanical integrity, photovoltaic modules, wind load 1 INTRODUCTION With the rapid depletion of fossil fuels, a paradigm shift to renewables has been observed in recent years. Extensive research is being carried out to explore sustainable and eco-friendly resources of energy. Much progress has been made in these efforts, focused mainly toward harnessing energy by water, wind, sun, and various other energy banks. Solar energy is a renewable energy source that is substantial and whose utilization is economically sustainable. Photovoltaics (PV) are This is an open access article under the terms of the Creative Commons Attribution License, which permits use, distribution and reproduction in any medium, provided the original work is properly cited.

show abstract

Section: Introductionmentioning

confidence: 99%