Monitoring local heating around an interventional MRI antenna with RF radiometry

Abstract

Purpose: Radiofrequency (RF) radiometry uses thermal noise detected by an antenna to measure the temperature of objects independent of medical imaging technologies such as magnetic resonance imaging (MRI). Here, an active interventional MRI antenna can be deployed as a RF radiometer to measure local heating, as a possible new method of monitoring device safety and thermal therapy. Methods: A 128 MHz radiometer receiver was fabricated to measure the RF noise voltage from an interventional 3 T MRI loopless antenna and calibrated for temperature in a uniformly heated bioanalogous gel phantom. Local heating (∆T) was induced using the antenna for RF transmission and measured by RF radiometry, fiber-optic thermal sensors, and MRI thermometry. The spatial thermal sensitivity of the antenna radiometer was numerically computed using a method-of-moment electric field analyses. The gel's thermal conductivity was measured by MRI thermometry, and the localized time-dependent ∆T distribution computed from the bioheat transfer equation and compared with radiometry measurements. A "H-factor" relating the 1 g-averaged ∆T to the radiometric temperature was introduced to estimate peak temperature rise in the antenna's sensitive region. Results: The loopless antenna radiometer linearly tracked temperature inside a thermally equilibrated phantom up to 73• C to within ±0.3 • C at a 2 Hz sample rate. Computed and MRI thermometric measures of peak ∆T agreed within 13%. The peak 1 g-average temperature was H = 1.36 ± 0.02 times higher than the radiometric temperature for any media with a thermal conductivity of 0.15-0.50 (W/m)/K, indicating that the radiometer can measure peak 1 g-averaged ∆T in physiologically relevant tissue within ±0.4• C. Conclusions: Active internal MRI detectors can serve as RF radiometers at the MRI frequency to provide accurate independent measures of local and peak temperature without the artifacts that can accompany MRI thermometry or the extra space needed to accommodate alternative thermal transducers. A RF radiometer could be integrated in a MRI scanner to permit "self-monitoring" for assuring device safety and/or monitoring delivery of thermal therapy. C 2015 American Association of Physicists in Medicine. [http://dx

Toward imaging the body at 10.5 tesla

“…Furthermore, incorporation of novel quantitative imaging methods that can perform in the presence of heterogeneous RF fields may alleviate the need of strict transmit field control . Numerical modeling, validation, and real‐time monitoring of RF safety will play an important role in successful implementation of pTx methods. Even though increasing B 0 and Larmor frequency poses challenges in terms of field uniformity and RF management, it also opens up new opportunities for transmit array design using higher element densities and channel counts.…”

Development and evaluation of a multichannel endorectal RF coil for prostate MRI at 7T in combination with an external surface array

“…To further ensure patient safety, the SAR near the ERC was based on a 1 g average as opposed to the standard 10 g average as a means to derive TAP limits. Further assessment of subject‐dependent shimming and its impact on local coupling and heating could be assessed by monitoring temperature through embedded fiberoptic sensors on the surface of the coil and/or using an RF radiometry method . Temperature monitoring of the coil surface may also identify additional constraints that need to be considered beyond SAR when using the ERC coils as transceivers.…”

Radiofrequency Ablation, MR Thermometry, and High-Spatial-Resolution MR Parametric Imaging with a Single, Minimally Invasive Device

“…MRI thermometry was performed using the proton resonance frequency (PRF)-shift method (20). A temperature coefficient of −0.01 ppm/°C was used to convert thermometric phase images acquired by the probe to temperature maps (20, 21). Large temperature changes near the probe causing ‘phase-wraps’ were unwrapped in the image field-of-view starting furthest (i.e., coolest) from the probe where phase-wraps were minimal, and proceeding towards it (SSH).…”