Molten salts :

Abstract

Research Council of the National Academy of Sciences-National Academy of Engineering provides. These services are organized under an overall Review Committee which considers the program as a whole and makes recommendations on policy, long-term planning, and international collaboration. Advisory Panels, each concerned with a single technical area, meet regularly to examine major portions of the program, assign relative priorities, and identify specific key problems in need of further attention. For selected specific topics, the Advisory Panels sponsor subpanels which make detailed studies of users' needs, the present state of knowledge, and existing data resources as a basis for recommending one or more data compilation activities. This assembly of advisory services contributes greatly to the guidance of NSRDS activities. The NSRDS-NBS series of publications is intended primarily to include evaluated reference data and critical reviews of long-term interest to the scientific and technical community.

The Surface Tension of the Molten Binary System LiCl-KCl

“…The agreement between our results and the accepted literature values (17) is within 1% (13). The agreement between our results and the accepted literature values (17) is within 1% (13).…”

“…The standard deviation of the points about the line is shown in the last column in Table I and is about 0.3 dyne/cm. Based on the agreement between our values for the surface tension of KNO~ and NaNO3 (13) and those reported by Janz (17), and the precision of all our data for the surface tension of LiCI-KC1 for which we estimate an accuracy of better than • we are unable to explain the differences between our values and those of Mizuno and Jaeger. Mizuno (5) reports surface tension data for the compositions 20, 40, and 60 m/o KC1.…”

“…The authors are indebted to Mr. T. R. Rhinehart for the design and fabrication of the surface tension apparatus, to Dr. J. G. Eberhart [13][14][15][16][17][18] 1973.…”

Direct prediction of molten alkali halides surface tension

“…Equation 1 has been checked against all the alkali halides, and the calculated values were found in good agreement with the reported data (Table 1) [7,[10][11][12][13][14][15][16][17][18][19][20][21]. Therefore, the described simple relation is considered as very useful for calculating the surface tension of molten alkali halides, at the melting point, in a straightforward fashion, and may be applied to molten alkaline earth halides.…”

Plasmonic Nanowire‐Enhanced Upconversion Luminescence for Anticounterfeit Devices

“…Relatively low pressure is not sufficient to form the strong GPP mode as observed in the original pNUM configuration, whereas too high pressure would destroy or interfere with the stable network of the AgNWs. [46,47] Thus, the force to separate the AgNWs network from the scotch tape is more than two times larger than that to separate the AgNWs network from the UCNPs monolayer. Moreover, by considering that the typical power density of a portable NIR source is relatively low (i.e., indicated by red dot vertical lines), the reattaching only recovers ≈0.1 of the original UCL intensity.…”