An efficient and durable oxygen evolution reaction (OER) catalyst is necessary for the water-splitting process toward energy conversion. The OER through water oxidation reactions could provide electrons for H 2 O, CO 2 , and N 2 reduction and produce valuable compounds. Herein, the FeNi (1:1 Ni/Fe) alloy as foam, after anodizing at 50 V in a two-electrode system in KOH solution (1.0 M), was characterized by Raman spectroscopy, diffuse reflectance spectroscopy (DRS), X-ray absorption spectroscopy (XAS), X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectrometry (EDX), transmission electron microscopy (TEM), high-angle annular darkfield imaging (HAADF)−scanning transmission electron microscopy (STEM) and used as an efficient and durable OER electrocatalyst in KOH solution (1.0 M). The overpotential for the onset of the OER based on extrapolation of the Tafel plot was 225 mV. The overpotentials for the current densities of 10 and 30 mA/cm 2 are observed at 270 and 290 mV, respectively. In addition, a low Tafel slope is observed, 38.0 mV per decade, for the OER. To investigate the mechanism of the OER, in situ surfaceenhanced Raman spectroscopy was used to detect FeNi hydroxide and characteristic peaks of H 2 O. Impurities in KOH can adsorb onto the electrode surface during the OER. Peaks corresponding to Ni(III) (hydr)oxide and FeO 4 2− can be detected during the OER, but high-valent FeNi (hydr)oxides are unstable and reduce under the open circle potential. Metal hydroxide transformations during the OER and anion adsorption should be carefully considered. In addition, Fe 3 O 4 may convert to γ-Fe 2 O 3 during the OER. This study aims to offer logical perspectives on the dynamic changes that occur during the OER under alkaline conditions in an anodized FeNi alloy. These changes encompass variations in morphology, surface oxidation, the generation of high-valent species, and phase conversion during the OER.