Modification of polymer films, coatings, and membranes

Timakova, K. A.; Тарасов, А. В.; Fedotov, Yu. А.; Lepeshin, S.A.; Panov, Yu. T.

doi:10.1134/s096554411207016x

Cited by 1 publication

(1 citation statement)

References 17 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Also, in order to increase the degree of emulsion separation and the specific performance of the membranes, they perform chemical or physical modification of the membranes. Chemical modification [8][9][10] is the treatment of surface membranes with various aggressive media, the application of a new working layer to the substrate, the provision of hydrophilicity or hydrophobic properties to the membrane surface, the change of membrane surface charge and the production of composite membranes. Physical modification of membranes provides for the impact on surface by electromagnetic waves and plasma; ultrasonic, thermal and radiation processing [11][12][13].…”

Section: Introductionmentioning

confidence: 99%

Modification of Membranes from Nylon by Microwave Radiation in Argon, Nitrogen and Atmospheric Air

Фазуллин¹,

Kharitonova²,

Маврин³

et al. 2018

IJET

View full text Add to dashboard Cite

Microfiltration thin-film membranes of nylon were treated with microwave radiation within the decimeter wavelength range in air, nitrogen and argon to increase the specific productivity and the degree of the resistant oil emulsion separation due to structural transformations in the surfaces and membrane pores. After the processing of nylon membrane in air, argon and nitrogen, the specific performance of the membranes increases during the filtration of distilled water by 1.3 times. This circumstance is connected, probably with the increase of membrane pore size. And when the oil emulsion is separated, the specific productivity is increased after the treatment in air and oxygen up to 2.3 times, and after the treatment in argon it is decreased by 2 times. The decrease in performance occurs apparently due to the crosslinking of the pores and the surface layer of the membrane. It has been established that the treatment of nylon membranes with microwave radiation in air, nitrogen and argon leads to the decrease of oil emulsion separation degree, which is explained by the membrane surface etching. The worst degree of purification makes 83% and it is observed after the separation of the emulsion with the membrane treated by microwave radiation in a nitrogen atmosphere, when the loss of membrane mass after the microwave treatment was 0.69%. The purification degree from oil is reduced in the least after the treatment in argon medium - 93, and the loss of membrane mass after treatment makes 0.26%.

show abstract