Modification of mineral fillers and their influence on properties of rubbers

Teshabayeva, Elmira; Ibodullayev, A.; Vapayev, Murod

doi:10.20534/ajt-16-3.4-125-128

Cited by 4 publications

(2 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…3). After modification of solid particles, it was found that the energy consumption decreased due to the increase in speed in the hydromix flow, the decrease in pressure loss, and the increase in the service life due to the decrease in friction in hydrotransport systems [16][17][18][19][20][21][22][23][24].…”

Section: Fig 2 Pressure Loss Due To Resistancementioning

confidence: 99%

“…For small sized particles (d0<1 mm) and large particles, the quantitative values of hydraulic resistance increase vary [3]. Pressure loss increases due to large particles (d0>1,5 mm) [20]. When solid particles of different sizes (heterogeneous) move in the flow, additional vortices appear around it due to various physical characteristics of the hydroaration flow, therefore, at the expense of which turbulent changes are observed and energy consumption increases.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Study of the motion of modified solid particles in hydratransport systems

Chorshanbiev,

Ibadullaev,

Babaev

et al. 2023

E3S Web of Conf.

View full text Add to dashboard Cite

The article examines the movement of solid particles, the hydraulic calculations of pipes in the process of movement, the classification of reducing the impact of solid particles on hydrotransport systems. The effect of solid particle magnification on flow rate, pressure loss, speed reduction as a result of the effect of internal friction forces of solid particles, friction in the flow of solid particle hydroarations, pressure loss as a result of the impact of Resistance Forces, internal corrosion process observed in the pipe, increased energy consumption were analyzed using the example of hydrotransport systems Recommendations have been made to solve the problems of speed reduction and pressure loss due to the movement of solid particles in the hydroaration flow through the modification method. The prior and subsequent movement of solid particles in a pipe modification is shown through comparison graphs. Information about the gossipol Tar selected as a modifier is provided.

show abstract