Modelling of recrystallisation textures in aluminium alloys: I. Model set-up and integration

Effect of grain shape on the texture evolution during cold rolling of Al–Mg alloys

“…Much research effort has been devoted to the modeling of rolling and recrystallization textures, with either empirically or mathematically based and physically based models [14][15][16][17][18][19][20][21][22][23][24][25]. Deformation texture is often simulated by using the full or relaxed constraints version of the Taylor-Bishop-Hill model [14][15][16], a rate-sensitive crystal plasticity model [17,18], and finite element calculations [19].…”

Recrystallization Modeling of AA8XXX Alloys with Cellular Automata Considering Recovering Kinetics

“…The deformation data is further useful to estimate the nucleation probabilities for recrystallization. Information on the efficiency of single grains for shear band nucleation and grain boundary nucleation can be obtained by applying the ReNuc model [21,22] on the GIA-3IVMþ output. The use of the GIA-Split Up model provides data on the efficiency of grains for transition band nucleation.…”

“…The use of the GIA-Split Up model provides data on the efficiency of grains for transition band nucleation. [21,22] Particle-stimulated nucleation was considered by a separate nucleation model. [23] For the consideration of particle stimulated nucleation, a particle volume fraction of 1.7 vol%, as measured in the hot-rolled state, was taken into account.…”

Simulation and Experimental Study of Recrystallization Kinetics of Nickel Based Single Crystal Superalloys

“…Till now, a lot of simulation on recrystallization has been conducted [14][15][16][17][18], but most about aluminium, magnesium and steel. Little work has been done on simulation of recrystallization of SX nickel-based superalloys.…”