Modeling and simulation of wind-PV hybrid power system using Matlab/Simulink

Kasera, Jitendra; Chaplot, Ankit; Maherchandani, Jai Kumar

doi:10.1109/sceecs.2012.6184769

Cited by 41 publications

(17 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A solar cell can be modelled by a current source and a diode which is connected in parallel to it. It has its allowable series and parallel resistance [4]. …”

Section: Modelling Of Hybrid System Components a Modeling Of Phomentioning

confidence: 99%

Investigation on Control of Hybrid Solar-Wind Generation System

Mali¹

2018

IJRASET

View full text Add to dashboard Cite

This paper presents simulation, modelling and control strategy for the stand-alone hybrid solar-wind energy conversion systems with battery storage. The proposed hybrid system consists of a photovoltaic (PV), wind energy conversion system (WECS), storage device, boost converter and an inverter to convert DC to AC. The PV is used as a main energy source and WECS as secondary source of supply. Battery is used as back-up energy source to increase the reliability of the system. Power delivered by different sources is controlled with the help of a supervisory controller, which set the reference signal for local control of each individual source. The modelling of proposed hybrid system is developed in MATLAB/SIMULINK environment.

show abstract

“…A solar cell can be modelled by a current source and a diode which is connected in parallel to it. It has its allowable series and parallel resistance [4]. …”

Section: Modelling Of Hybrid System Components a Modeling Of Phomentioning

confidence: 99%

Investigation on Control of Hybrid Solar-Wind Generation System

Mali¹

2018

IJRASET

View full text Add to dashboard Cite

show abstract

“…(8). The torque T and output power P m generated from the wind turbine within the interval are [V min , V max ], where V min and V max are functions of the wind speed, air pressure, turbine blade radius, and coefficients C P and C q [3][4][5]. The wind turbine is modeled in MATLAB/Simulink using following Eqs.…”

Section: Modeling Of Wind Turbinementioning

confidence: 99%

Design and Analysis of Grid Connected Wind/PV Hybrid System

Krishna

Kumar

Edward

et al. 2016

Proceedings of the International Congress on Information and Communication Technology

View full text Add to dashboard Cite

In this article, the design and analysis of wind/PV hybrid system which is grid connected has been presented. The wind and photovoltaic sources are integrated at the DC bus and its voltage is stepped up to desired value using DC-DC boost converter. The proportional integral controller has been used to control the output power produced from wind and photovoltaic resources to achieve desired output response. A variable speed control method is implemented for permanent magnet synchronous wind generator, which is capable of extracting maximum power even if it is operated at wind speed which is lower than the rated speed. The power produced from wind/PV hybrid system is supplied to the load and in the case of excess power generation it is supplied to the grid. The proposed hybrid system is modeled in MATLAB/Simulink. The performance of the system is evaluated by not only considering the changes in wind speed and solar irradiance but also by load power variations. The simulation results show that the proposed hybrid wind/PV system is a viable option for microgrid applications.

show abstract

“…The equivalent circuit PV cell is shown in Fig. 1 and the mathematical model of the PV array is given in (1) [8,9].…”

Section: Pv Arraymentioning

confidence: 99%

Research on large-scale dispatchable grid-connected PV systems

Han

Xin

Sun

2014

J. Mod. Power Syst. Clean Energy

View full text Add to dashboard Cite

This paper describes the research on a largescale dispatchable grid-connected photovoltaic (PV) system for supplying power to the grid for dispatch instead of supplying the electricity to a local load. In order to maximise the value of the solar energy, a hybrid electricity storage consisting of batteries and supercapacitors is used with the PV system. This paper proposes a control strategy focusing on the DC power at the DC link rather than at the grid-connected inverter. Two typical sets of real data, collected from existing sites, are used to demonstrate the practicality of the system. Finally, the simulation results are used to demonstrate the good performance and feasibility of the proposed system together with the proposed control strategy.

show abstract

Modeling and simulation of wind-PV hybrid power system using Matlab/Simulink

Cited by 41 publications

References 2 publications

Investigation on Control of Hybrid Solar-Wind Generation System

Investigation on Control of Hybrid Solar-Wind Generation System

Design and Analysis of Grid Connected Wind/PV Hybrid System

Research on large-scale dispatchable grid-connected PV systems

Contact Info

Product

Resources

About