Microwave Biomedical Sensors With Stable Response: Basic Idea and Preliminary Numerical Assessments for Blood Glucose Monitoring

Abstract

Microwave sensors are gaining increasing interest in blood glucose detection, for their potential ability to perform a continuous non-invasive monitoring of the glucose concentration, by relating the change in the blood dielectric properties to a variation in the glucose level. Usually, the involved body part (phantom) is placed on the sensor to perform the reading. However, the placement modality, as well as other external factors not related to the blood glucose concentrations (BGC) (i.e. system noise, environmental temperature, human tissues variations other than blood tissue) may also have an effect on the sensor response, due to the change in the propagation path of the electromagnetic field inside the body part under test. In this work, the variation effects induced on the microwave sensor response by the changes in the thickness and the dielectric properties of skin and fat tissues are analyzed and faced. In particular, to mitigate the above drawback in terms of sensor instability, a solid ''matching layer'' is interposed between the resonant sensor and the phantom under test. A specific optimization procedure is performed to design microwave sensors with a stable response not influenced by variations in tissues different from the blood. Various sensors configurations with related resolution metrics are considered to assess the proposed idea and design methodology. Numerical results confirm the possibility to achieve a good trade-off between the measurement stability against undesired phantom variations and the sensitivity toward blood glucose levels, allowing to discriminate concentrations in the range of [100-300] mg/dL. Antennas, electromagnetics, propagation, measurements. INDEX TERMS

Microwave Radar Imaging as a Tool for Medical Diagnostics

“…Nevertheless, our system has the advantages that if a matching strategy is needed (i.e., a different antenna is employed), this can be be achieved by adopting a solid dielectric layer posed exactly in correspondence at the antennas' housing. Obviously, in the antenna optimization procedure, even the properties (i.e., dielectric and geometrical) of matching material must be taking into account [29].…”