Microstructure, mechanical properties and reciprocal dry sliding wear behaviour of as-cast and heat-treated TiN/Al-7Si functionally graded composite

Abstract

This work explores the effect of T6 heat-treatment on the microstructure, mechanical properties and dry sliding linear reciprocating wear behaviour of Al-7Si/Titanium Nitride (TiN) centrifugally cast functionally graded composite. The 10 wt% TiN particle addition and subsequent eutectic Si spheroidisation due to heat treatment revealed an improvement in microhardness, tensile strength and wear resistance of heat-treated composite when compared to as-cast composite. Reciprocating wear analysis at varying applied loads and sliding distances revealed a combination of specimen micro-ploughing and abrasive particle action at low load and sliding distances, which was in stark contrast to the combination of abrasive and adhesive wear at higher loads and sliding distances. The surface was characterised by mechanically mixed layer formation due to tribo-oxidation, adhesive and delamination wear mechanisms. This composite can be utilised to replace traditional materials employed in reciprocating pump and compressor applications.

Influence of nano-TiO2 particles on the microstructure, mechanical and wear behaviour of AA7178 alloy matrix fabricated by stir casting technique

“…Micro-ploughing causes distortion when wear is minor, and micro-cutting causes deformation when the wear is severe. 39–41…”

Wear performance analysis and optimization of process parameters of novel AA7178/nTiO2 using ANN-GRA method

“…There are many different types of metal matrix elements, however, aluminium is the predominant matrix material utilized because of its superior physical and mechanical qualities. B 4 C, SiC, TiN, TiO 2 , SiO 2 , ZrB 2 , TiC, and Al 2 O 3 1–13 are various reinforcing elements incorporated with metal matrix further to enhance their mechanical as well as wear properties. These alloys have a very low specific gravity and may be found in a variety of finished products owing to their application in the automotive and aerospace production sectors.…”

Optimization of tribological behaviour of TiO2 nanoparticles reinforced AA7178 alloy matrix using ANN and Taguchi’s methodology

“…However, wear loss was enhanced by enhancing the sliding load and distance. J Radhakrishnan et al [17] reported that wear loss increased when enhancing the load, while friction coefficient decreased. Grooves pulled out of particles were seen in the morphological study of worn-out surface of Al-Si composite.…”