Restrictive operating conditions (even exceeding 700 °C) of materials in advanced ultra super critical (AUSC) power plants and the need to minimize manufacturing and maintenance costs require the production of dissimilar metal welded joints (DMW). Significant differences in the physical and chemical properties of welded materials lead to phenomena that reduce the weldability of the metals used and force the search for solutions that limit unfavorable phenomena, e.g., the use of buttering layers. The study presents a comparison of two types of joints with Alloy 617 (UNS N06617) and ferritic P92 (UNS K92460) steel made using Inconel 82 (ENiCrFe-3) and Inconel 617 (ERNiCrCoMo-1) alloys buttering layer and the corresponding chemical composition of filler metals. All areas of the joints made with the gas tungsten arc welding process were subjected to structural investigations (optical microscopy, scanning electron microscopy (SEM), and energy-dispersive X-ray spectroscopy (EDS) and mechanical tests (microhardness, room and high temperature tensile, and toughness testing). Despite the more complicated welding procedure, sound welded joints were obtained with favorable properties resulting, inter alia, from the reduced thickness of the martensite layer in HAZ of P92 steel and the limited diffusion of alloy components compared to welded joints without the buttering layer. This also resulted in a reduction of the maximum hardness (especially in the case of Inconel 82 buttering—by 15–30 HV0.5 in comparison with Inconel 617 buttering) and an increase in strength while limiting the decrease in plasticity (even 663 MPa tensile strength and 21% of elongation for Inconel 617 buttered joint). Moreover, improved high-temperature performance (approximately 70–100 MPa) of the welded joint following the application of the buttering layer was confirmed. The presented results allow for drawing general conclusions that both proposed welding procedures can be recommended for use in the working conditions occurring at AUSC.
