Microemulsion formulation of clonixic acid: solubility enhancement and pain reduction

Abstract

Clonixic acid is currently marketed as a salt form because of its poor water-solubility. However, the commercial dosage form causes severe pain after intramuscular or intravenous injection. To improve the solubility of clonixic acid and to reduce pain on injection, clonixic acid was incorporated into oil-in-water microemulsions prepared from pre-microemulsion concentrate composed of varying ratios of oil and surfactant mixture. As an oil phase for drug incorporation, up to 14% castor oil could be included in the pre-microemulsion concentrate without a significant increase in droplet size. Both drug contents and droplet size increased as the weight ratio of Tween 20 to Tween 85 decreased. Taken together, when microemulsions were prepared from pre-microemulsion concentrate composed of 5:12:18 weight ratio of castor oil:Tween 20:Tween 85, clonixic acid could be incorporated at 3.2 mg mL(-1) in the microemulsion with a droplet size of less than 120 nm. The osmotic pressure of this microemulsion was remarkably lower than the commercial formulation, irrespective of the dilution ratios. The rat paw-lick test was used to compare pain responses among formulations. The microemulsion formulation significantly reduced the number of rats licking their paws as well as the total licking time, suggesting less pain induction by the microemulsion formulation. The pharmacokinetic parameters of clonixic acid after intravenous administration of the clonixic acid microemulsion to rats were not significantly different from those of the commercial formulation, lysine clonixinate. The present study suggests that microemulsion is an alternative formulation for clonixic acid with improved characteristics.

Biocompatible Microemulsions and Their Prospective Uses in Drug Delivery

“…The osmotic pressure of the vehicle was remarkably lower than the commercial formulation. In vivo studies indicated less pain in injection by the microemulsion formulation but the pharmacokinetic parameters were not significantly different 120…”

New perspectives on lipid and surfactant based drug delivery systems for oral delivery of poorly soluble drugs

“…Further medium-chain triacylglycerides are widely used in SMEDDS Type III, due to their higher polarity compared with long-chain triacylglycerides, which facilitates the emulsification process. [37,52,64,66,72,74,75] Other lipid phases that have been employed are ethyl oleate [52] and oleic acid. [74] In conclusion the LFCS does not encompass all the SEDDS and SMEDDS that have recently been used in research and thus would benefit from being updated as suggested in the present review.…”

Application of nanogel systems in the administration of local anesthetics

“…From the work of Lee et al,63 injections made with nanogels are less painful when compared with cosolvent-based formulation. High blood circulation time could be achieved due to the size of the nanogels, which is very important to extend the therapeutic efficacy of the LA.…”