Micro-mesoporous carbon fabricated by Phanerochaete chrysosporium pretreatment coupling with chemical activation: Promoting effect and toluene adsorption performance

Ultrasonic-assisted in situ synthesis of MOF-199 on the surface of carboxylated cellulose fibers for efficient adsorption of methylene blue

“…2(d) displays the N 2 adsorption–desorption curves for the three materials, and the curves were used to analyze the specific surface area and pore size of the materials. 34 MOF-199 and MOF-199/CCF exhibit typical type I adsorption curves, with high adsorption capacity in the low-pressure region, indicating a large number of micropores in the material. The H4 hysteresis rings in the high-pressure area indicate the presence of mesopores, mainly generated by particle accumulation.…”

“…d) displays the N 2 adsorption-desorption curves for the three materials, and the curves were used to analyze the specic surface area and pore size of the materials 34. MOF-199 and MOF-199/CCF exhibit typical type I adsorption curves,…”

Defect-rich N doped porous carbon derived from Camellia shells for chlorobenzene adsorption

“…Since the internal transmission channels of porous carbon were mostly formed by the arrangement and connection of mesopores, the increase in mesopores was conducive to the rapid diffusion of VOCs in the pores and reduced the mass transfer resistance. 35…”

“…Since the internal transmission channels of porous carbon were mostly formed by the arrangement and connection of mesopores, the increase in mesopores was conducive to the rapid diffusion of VOCs in the pores and reduced the mass transfer resistance. 35 The structural properties of ANOC-x and AOC were studied using XRD and Raman spectroscopy. The XRD spectrum of porous carbon is shown in Fig.…”

On-Line Thermally Induced Evolved Gas Analysis: An Update—Part 1: EGA-MS

“…The prepared micro-mesoporous carbon has simultaneously high specific surface areas and proportions of mesopores. The promoting effect determined by EGA-MS implied that P. chrysosporium treatment increases surface oxygen-containing groups [ 255 ]. Nitrogen and/or sulfur-doped carbons were extensively investigated as CO 2 adsorbents.…”