Mechanical properties and fracture behaviors of epoxy composites with phase-separation formed liquid rubber and preformed powdered rubber nanoparticles: A comparative study

Abstract

Epoxy composites filled with phase‐separation formed submicron liquid rubber (LR) and preformed nanoscale powdered rubber (PR) particles were prepared at different filler loading levels. The effect of filler loading and type on the rheological properties of liquid epoxy resin suspensions and the thermal and mechanical properties of the cured composites as well as the relative fracture behaviors are systematically investigated. Almost unchanged tensile yield strength of the cured epoxy/PR composites is observed in the tensile test compared with that of the neat epoxy; while the strength of the cured epoxy/LR composites shows a maximum value at ∼4.5 wt% and significantly decreases with increasing LR content. The glass transition temperature (Tg) of the cured PR/epoxy has shifted to the higher temperature in the dynamic mechanical thermal analysis compared with that of the cured pure epoxy and epoxy/LR composites. Furthermore, the presence of LR results in highly improved critical stress intensity factor (KIC) of epoxy resin compared with the corresponding PR nanoparticles. In particular, the PR and LR particles at 9.2 wt% loading produce about 69 and 118% improvement in KIC of the epoxy composites, respectively. The fracture surface and damage zone analysis demonstrate that these two types of rubber particles induce different degrees of local plastic deformation of matrix initiated by their debonding/cavitation, which was also quantified and correlated with the fracture toughness of the two epoxy/rubber systems. POLYM. COMPOS., 36:785–799, 2015. © 2014 Society of Plastics Engineers

On the mechanical behavior of basalt fiber/epoxy composites filled with silanized graphene oxide nanoplatelets

“…16). The agglomerates are considered as suitable sites for stress concentration [58]. It is well consistent with the results of mechanical tests, where the mechanical properties of the 0.5 wt% S-GONPs filled composite to be reduced, as compared with the specimen containing 0.4 wt% S-GONPs.…”

Nanostructured epoxy—rubber network modified with mwcnt and ionic liquid: Electrical, dynamic‐mechanical, and adhesion properties

“…For example, the use of rubber soft particles with silica nanoparticles , organoclay , or reduced graphene oxide in epoxy matrices resulted in considerable improvement of toughening without damaging the stiffness of the corresponding epoxy networks. Also the use of liquid rubber constituted by a mixture of carboxyl‐terminated polyurethane‐co‐polyether block copolymer and preformed powdered carboxylic nitrile‐butadiene rubber as soft and rigid particles, respectively, gave rise to improved impact strength when compared with the epoxy binary blends .…”

Interaction of toughening mechanisms in ternary nanocomposites

“…However, this type of structure also has shortcomings, such as inherently low fracture toughness and hence poor resistance to fracture. Many types of second phase modifiers, such as silica particles , rubber particles , carbon nanotubes , and nano‐clay , are blended into the epoxies to improve their fracture toughness.…”