Mechanical Characteristics and Vibration Control of Railway Signal Relay

Abstract

INTRODUCTION: In order to solve the problems of time-consuming and poor effects of traditional mechanical vibration control methods for the relay, the mechanical characteristics and vibration control of railway signal relays are studied in this paper. Based on the analysis of the mechanical characteristics of railway signal relays, the mechanical characteristic parameters of the relay, such as contact force, initial pressure, contact clearance, and overtravel are explored. On this basis, mechanical vibration control is completed based on particle swarm optimization. METHOD: First, sensors are used to collect the data on the railway signal relay, and the mechanical vibration control model of the railway signal relay is built. Then, the structure of the PID vibration controller and LQR vibration controller in the model is analyzed. Finally, the controller parameters are adjusted through particle swarm optimization to improve the mechanical vibration control effect of the relay. objective: However, most of the research on mechanical vibration control is aimed at the mechanical arm, which is not applicable to the mechanical vibration control of railway signal relay. Therefore, this paper studies the mechanical characteristics and vibration control of railway signal relay in order to improve the vibration control effect of railway signal relay. RESULT: The simulation results show that the average signal-to-noise ratio of the method is 67dB, the collected data has low noise, and the control time is short, which is 1.4s. CONCLUSION: The displacement of the railway signal relay controlled by the method is always less than 0.15mm, and the control effect is good, which can be widely used in practice. other: The effectiveness of the method is verified by experiments, it shows that the method can improve the effect and efficiency of mechanical vibration control of railway signal relay, and can be further promoted in practice.