Mechanical behaviour of self-compacting concrete made with recovery filler from hot-mix asphalt plants

Esquinas, Álvaro Romero; Ramos, Catarina; Jiménez, José Ramón; Fernández, José Antonio Fernández; Brito, Jorge de

doi:10.1016/j.conbuildmat.2016.11.063

Cited by 42 publications

(31 citation statements)

References 42 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Airey and Collop indicate that slab-compacted specimens are more closely correlated with cores sampled from the road surface than gyratory and vibratory-compacted specimens [11]. There are also self-compacting mixes, e.g., mastic asphalt, often used in bridge structures [23] or SCC cement concrete [24].…”

Section: Introductionmentioning

confidence: 99%

Laboratory Methods for Assessing the Influence of Improper Asphalt Mix Compaction on Its Performance

2020

View full text Add to dashboard Cite

Compaction index is one of the most important technological parameters during asphalt pavement construction which may be negatively affected by wrong asphalt paving machine set, weather conditions, or the mix temperature. Presented laboratory study analyzes the asphalt mix properties in case of inappropriate compaction. The reference mix was designed for AC 11 S wearing layer (asphalt concrete for wearing layer with maximum grading of 11 mm). Asphalt mix samples used in the tests were prepared using Marshall device with the compaction energy of 2 × 20, 2 × 35, 2 × 50, and 2 × 75 blows as well as in a roller compactor where the slabs were compacted to various heights: 69.3 mm (+10% of nominal height), 66.2 mm (+5%), 63 mm (nominal), and 59.9 mm (−5%) which resulted in different compaction indexes. Afterwards the samples were cored from the slabs. Both Marshall samples and cores were tested for air void content, stiffness modulus in three temperatures, indirect tensile strength, and resistance to water and frost indicated by ITSR value. It was found that either insufficient or excessive level of compaction can cause negative effect on the road surface performance.

show abstract

Section: Introductionmentioning

confidence: 99%

Laboratory Methods for Assessing the Influence of Improper Asphalt Mix Compaction on Its Performance

2020

View full text Add to dashboard Cite

show abstract

“…Obtaining cement-based materials made with RA (obtained from the treatment of C&DWs) has been one of the most studied applications. Although, indeed, there are currently some reliable studies that support the use of C&DW in conventional concrete [ 16 , 17 , 18 , 19 , 20 , 21 , 22 ], in recent years some studies on the use of RA have begun to be published with self-compacting concrete (SCC), although they are still rare [ 23 , 24 , 25 , 26 , 27 , 28 , 29 , 30 , 31 , 32 , 33 , 34 , 35 , 36 , 37 , 38 , 39 ]. Most of these studies compare the various fresh and hardened properties of SCC with RA and without RA (natural aggregates), apart from SCC mix design.…”

Section: Introductionmentioning

confidence: 99%

Influence of Design Parameters on Fresh Properties of Self-Compacting Concrete with Recycled Aggregate—A Review

Martínez‐García

Jagadesh²,

Fraile‐Fernández

et al. 2020

Materials

View full text Add to dashboard Cite

This article presents an overview of the bibliographic picture of the design parameter’s influence on the mix proportion of self-compacting concrete with recycled aggregate. Design parameters like water-cement ratio, water to paste ratio, and percentage of superplasticizers are considered in this review. Standardization and recent research on the usage of recycled aggregates in self-compacting concrete (SCC) exploit its significance in the construction sector. The usage of recycled aggregate not only resolves the negative impacts on the environment but also prevents the usage of natural resources. Furthermore, it is necessary to understand the recycled aggregate property’s role in a mixed design and SCC properties. Design parameters are not only influenced by a mix design but also play a key role in SCC’s fresh properties. Hence, in this overview, properties of SCC ingredients, calculation of design parameters in mix design, the effect of design parameters on fresh concrete properties, and the evolution of fresh concrete properties are studied.

show abstract

“…Studies on the application of calcium waste dust from the preparation of aggregate in concrete in HMA plants have not been published so far, except for works by Esquinas et al [33,34]. The analysis of the influence of dolomite waste powder from HMA plants carried out by [33,34] concerned the mechanical properties and durability features of self-compacting concrete in which a traditional filler was replaced by waste. According to [34], it is possible to obtain comparable results of technological features related to self-compaction of concrete with traditional filler and waste.…”

Section: Introductionmentioning

confidence: 99%

“…The analysis of the influence of dolomite waste powder from HMA plants carried out by [33,34] concerned the mechanical properties and durability features of self-compacting concrete in which a traditional filler was replaced by waste. According to [34], it is possible to obtain comparable results of technological features related to self-compaction of concrete with traditional filler and waste. Concretes made of waste showed lower compression strength, lower splitting strength, lower bending strength [34].…”

Section: Introductionmentioning

confidence: 99%

“…According to [34], it is possible to obtain comparable results of technological features related to self-compaction of concrete with traditional filler and waste. Concretes made of waste showed lower compression strength, lower splitting strength, lower bending strength [34]. According to [33], concrete with the addition of waste powder had a higher porosity than concrete with traditional filler.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

The Durability of Concrete Modified by Waste Limestone Powder in the Chemically Aggressive Environment

et al. 2019

View full text Add to dashboard Cite

The idea of sustainable development assumes that natural resources must be treated as limited goods and that waste must be managed rationally. This idea and the constant striving to reduce production costs make the use of waste materials as substitutes for traditionally used raw materials from non-renewable sources increasingly popular. In cement concrete technology, there are many possibilities to use waste as components of mortars and concretes. The subject of this paper is a fine-grained material, obtained as a by-product during the preparation of aggregate for mineral-asphalt mixtures. The aim of the research was to test the suitability of the selected type of powder, namely limestone powder, as a component of cement composites. The paper presents an evaluation of the potential of using the limestone powder as a substitute for the fine aggregate, focusing on the impact of such a modification on aspects of durability. The sulfate degradation and chloride ion diffusion in concrete were investigated. The overall desirability function has been determined. It was demonstrated that the satisfactory value of the general desirability can be attributed to most of the investigated concretes. Positive test results support the potential of replacing part of natural fine aggregate with the tested waste limestone dust without a negative impact on the durability of concrete.

show abstract

Mechanical behaviour of self-compacting concrete made with recovery filler from hot-mix asphalt plants

Cited by 42 publications

References 42 publications

Laboratory Methods for Assessing the Influence of Improper Asphalt Mix Compaction on Its Performance

Laboratory Methods for Assessing the Influence of Improper Asphalt Mix Compaction on Its Performance

Influence of Design Parameters on Fresh Properties of Self-Compacting Concrete with Recycled Aggregate—A Review

The Durability of Concrete Modified by Waste Limestone Powder in the Chemically Aggressive Environment

Contact Info

Product

Resources

About