Mechanical antithrombogenic properties by vibrational excitation of the impeller in a magnetically levitated centrifugal blood pump

Abstract

Mechanical circulatory support devices have been used clinically for patients with heart failure for over 10 years. However, thrombus formation inside blood pumps remains a risk to patient life, causing pump failure and contributing to neurological damage through embolization. In this article, we propose a method for preventing thrombus formation by applying vibrational excitation to the impeller. We evaluate the ability of this method to enhance the antithrombogenic properties of a magnetically levitated centrifugal blood pump and ensure that the impeller vibration does not cause undue hemolysis. First, 3 vibrational conditions were compared using an isolated pump without a mock circulation loop; the vibrational excitation frequencies and amplitudes for the impeller were set to (a) 0 Hz‐0 μm, (b) 70 Hz‐10 μm, and (c) 300 Hz‐2.5 μm. The motor torque was measured to detect thrombus formation and obtain blood coagulation time by calculating the derivative of the torque. Upon thrombus detection, the pump was stopped and thrombi size were evaluated. The results showed an increase in the blood coagulation time and a decrease in the rate of thrombus formation in pumps with the impeller vibration. Second, an in vitro hemolysis test was performed for each vibrational condition to determine the effect of impeller vibration on hemolysis. The results revealed that there was no significant difference in hemolysis levels between each condition. Finally, the selected vibration based on the above test results and the non‐vibration as control were compared to investigate antithrombogenic properties under the continuous flow condition. The blood coagulation time and thrombi size were investigated. As a result, vibrational excitation of the impeller at a frequency of 300 Hz and amplitude of 2.5 μm was found to significantly lengthen clotting time, decreasing the rate of pump thrombus compared to the non‐vibration condition. We indicate the potential of impeller vibration as a novel mechanical antithrombogenic mechanism for rotary blood pumps.

Impeller (straight blade) design variations and their influence on the performance of a centrifugal blood pump

“…The average nondimensional y + of any wall is controlled to be less than 1.5. 17 The largest y + is 3.6 in the volute, smaller than 4, which is compatible with enhance wall treatment. 18 The same meshes for the inlet port and volute passage are employed for different blade designs.…”

Artificial Organs 2019: A year in review

“…Tomotaka Murashige and Wataru Hijikata of the Tokyo Institute of Technology, Meguro, Japan investigated applying vibrational excitation to the impeller for preventing thrombus formation by applying vibrational excitation to the impeller of a magnetically levitated centrifugal blood pump. Three vibrational conditions were compared using an isolated pump without a mock circulation loop; the vibrational excitation frequencies and amplitudes for the impeller were set to (a) 0 Hz‐0 μm, (b) 70 Hz‐10 μm, and (c) 300 Hz‐2.5 μm.…”

Direct Suspension Control Based on Second Order Sliding Mode for Bearingless Brushless Dc Motor

“…For the closed-loop control of suspension force, it is necessary to observe the suspension force first. The estimation of suspension force can be calculated by Equations (1)- (3). At the same time, a two-point suspension force regulator is used, as shown in Fig.…”

“…It also has the advantages of bearingless motor of high integration, no mechanical wear, long service life, and no pollution [2]. BBLDCM has high research value and wide application prospects in biomedical fields such as blood pumps, high-speed/ultra-high-speed centrifuges, surgical cutting chainsaws, new energy fields, e.g., flywheel energy storage and aerospace [3][4][5][6][7][8][9].…”