Mechanical and Physical Properties of Particleboard Made from the Sumatran Elephant (Elephas maximus sumatranus) Dung and Wood Shaving

Abstract

Sumatran elephants (Elephas maximus sumatranus) are the world’s largest living land mammals. The elephant’s digestive system can only absorb 40% of the nutrients in digested feed, and the remainder is excreted as dung. Elephant dung waste can be used as a particleboard material due to its high fiber content. The objectives of this study are: (i) to prepare elephant dung waste as raw material for particleboard, (ii) to improve elephant dung particleboard’s physical and mechanical properties using wood shavings, and (iii) to study the influence of several parameters on the physical and mechanical properties of particleboard. The particleboard dimensions and density were set at 20 cm × 20 cm × 1 cm and 0.8 g/cm3, respectively. The mixture ratio of elephant dung and wood shavings was 100/0, 90/10, 80/20, 70/30, 60/40, and 50/50 (% w/w). This mixture ratio of particles was sprayed with 7% isocyanate adhesive. The pressing at a pressure of 30 kg/cm2 for 5 min and 160 °C was used in this study. The physical and mechanical properties of particleboard were tested according to JIS A 5908 (2003) standard. The result shows that the addition of wood shaving improved the elephant dung particleboard’s physical and mechanical properties. Except for moisture content and water absorption, the addition of wood shavings has a significant effect on elephant dung particleboard’s physical and mechanical properties. The best ratio of elephant dung and wood-shaving for this research is 50/50 and has fulfilled the JIS A 5908-2003 standard, except for thickness swelling.

Effect of fibrillation degree of empty fruit bunch fiber on sandwich composite incorporate with spent mushroom substrate

“…13 It was reported that, these fiber physical changes had contributed the composite panel to obtain a better dimensional stability and low spring back force effect due to reduction of accumulated pressure between fiber particles during the composite hot press process. 14 A greater spring back force effect can also occur when the fabrication of composite panel is using large fibers and low-density fiber particles. 15 Technically, large and low-density fiber particles tend to cause the fiber to experience greater bulky effect and create greater pressure during the hot press.…”

Selected Properties of Single and Multi-Layered Particleboards with the Structure Modified by Fibers Implication

“…The particleboards’ structure modification by fibers can lead not only to a surface quality improvement but also to selected mechanical and physical properties modification. According to Hartono et al [ 14 ], the addition of wood shavings improves the elephant dung particleboard’s physical and mechanical properties, especially when the ratio of elephant dung and wood shavings reaches 1:1. The only weakness of the tested panels was moisture content and water absorption, since they did not improve when the panels’ structure has been modified [ 15 ].…”

Coated Particleboards based on Castor Stalk Waste as an Alternative to Artificial Wood: (Part II)

“…The plant is a durable annual that may reach heights of 2 to 5 meters, but because it is moisture sensitive, it performs best when planted during the rainy season [12]. Particleboard is a material that is produced in huge quantities and is mostly used to make furniture since it has strong mechanical qualities and is easy to work with [13,14]. It is the most widely used panel material for non-structural uses.…”