Measurement of Total Dissolved Solids and Total Suspended Solids in Water Systems: A Review of the Issues, Conventional, and Remote Sensing Techniques

Abstract

This study provides a comprehensive review of the efforts utilized in the measurement of water quality parameters (WQPs) with a focus on total dissolved solids (TDS) and total suspended solids (TSS). The current method used in the measurement of TDS and TSS includes conventional field and gravimetric approaches. These methods are limited due to the associated cost and labor, and limited spatial coverages. Remote Sensing (RS) applications have, however, been used over the past few decades as an alternative to overcome these limitations. Although they also present underlying atmospheric interferences in images, radiometric and spectral resolution issues. Studies of these WQPs with RS, therefore, require the knowledge and utilization of the best mechanisms. The use of RS for retrieval of TDS, TSS, and their forms has been explored in many studies using images from airborne sensors onboard unmanned aerial vehicles (UAVs) and satellite sensors such as those onboard the Landsat, Sentinel-2, Aqua, and Terra platforms. The images and their spectral properties serve as inputs for deep learning analysis and statistical, and machine learning models. Methods used to retrieve these WQP measurements are dependent on the optical properties of the inland water bodies. While TSS is an optically active parameter, TDS is optically inactive with a low signal–noise ratio. The detection of TDS in the visible, near-infrared, and infrared bands is due to some process that (usually) co-occurs with changes in the TDS that is affecting a WQP that is optically active. This study revealed significant improvements in incorporating RS and conventional approaches in estimating WQPs. The findings reveal that improved spatiotemporal resolution has the potential to effectively detect changes in the WQPs. For effective monitoring of TDS and TSS using RS, we recommend employing atmospheric correction mechanisms to reduce image atmospheric interference, exploration of the fusion of optical and microwave bands, high-resolution hyperspectral images, utilization of ML and deep learning models, calibration and validation using observed data measured from conventional methods. Further studies could focus on the development of new technology and sensors using UAVs and satellite images to produce real-time in situ monitoring of TDS and TSS. The findings presented in this review aid in consolidating understanding and advancement of TDS and TSS measurements in a single repository thereby offering stakeholders, researchers, decision-makers, and regulatory bodies a go-to information resource to enhance their monitoring efforts and mitigation of water quality impairments.

Identification of Industrial Heat Source Production Areas Based on SDGSAT-1 Thermal Infrared Imager

“…(2) Optical features Optical features are extracted from optical remote sensing images by sensors that detect electromagnetic radiation in the visible, near-infrared, and sometimes shortwave infrared regions of the electromagnetic spectrum [44]. They provide valuable information about the Earth's surface, especially land cover information [45].…”

Monitoring Dissolved Oxygen Concentrations in the Coastal Waters of Zhejiang Using Landsat-8/9 Imagery

“…Based on the dataset, we expanded our analysis of Landsat-8/9 single-band images by combining the reflectance of six different bands to create 15 datasets with various band ratios. These ratios are used as inputs in our model, and they help reduce atmospheric effects and improve the precision of water quality parameters (WQPs) [35]. We performed a correlation analysis that connected six single bands, 15 band ratios, SST remote sensing data, and DO levels.…”

Pollution Load Reduction from Domestic Wastewater with Electrocoagulation Process for Agricultural Reuse

“…The sediments also cause fish death by clogging of gills, suffocation of fish eggs, and benthic organisms. The suspended matter is proportional to the microbial load in the water which interferes with treatment processes to negatively influence the water quality (13) . TDS is represented by dissolved organic and inorganic substances (minerals and ions etc.)…”