2012
DOI: 10.1109/lawp.2011.2182594
|View full text |Cite
|
Sign up to set email alerts
|

Measurement of Radiation Efficiency of Multiport Antennas With Feeding Network Corrections

Abstract: Multiport antennas are widely used and often integrated with active components, such as low noise amplifiers, in antenna systems. It is important to verify and evaluate the radiation efficiency of a multiport antenna before being integrated in the system. When the radiation efficiency of a multiport antenna is measured, a multiport feeding network is always needed in order to provide the same antenna excitation as it is during its operation after being integrated in the system. This letter addresses how to mea… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
2

Citation Types

0
10
0

Year Published

2012
2012
2021
2021

Publication Types

Select...
10

Relationship

7
3

Authors

Journals

citations
Cited by 16 publications
(10 citation statements)
references
References 14 publications
0
10
0
Order By: Relevance
“…But the results shown in Fig. 15 are only for the Eleven feed with the center puck circuit board, where the measured data are obtained by removing the ohmic loss in the feeding network (the hybrids and combiner), using a rigorous calibration method presented in [29]. The reason for the measured frequency range of only 1.…”
Section: Simulated and Measured Resultsmentioning
confidence: 99%
“…But the results shown in Fig. 15 are only for the Eleven feed with the center puck circuit board, where the measured data are obtained by removing the ohmic loss in the feeding network (the hybrids and combiner), using a rigorous calibration method presented in [29]. The reason for the measured frequency range of only 1.…”
Section: Simulated and Measured Resultsmentioning
confidence: 99%
“…The simulated and measured co-polar directivities in the upper band are shown in The radiation efficiency of the antenna prototype, which is a measure of its ohmic losses, as well as the total radiation efficiency that takes both its ohmic and mismatch losses into account, was measured in a Blue test reverberation chamber [15], where the measurement uncertainty is 0.5 dB [16]. The measured data were obtained by using a rigorous calibration method presented in [17]. It can be observed from Fig.…”
Section: Measured Resultsmentioning
confidence: 99%
“…All ohmic losses are therefore implemented in this model. The measured data are obtained by using a rigorous calibration method presented in [31].…”
Section: Simulated and Measured Resultsmentioning
confidence: 99%