Measurement of pollution levels of N-nitroso compounds of health concern in water using ultra-performance liquid chromatography–tandem mass spectrometry

Abstract

International audienceThis paper reports the development of a highly sensitive analytical method combining solid-phase extraction (SPE) with ultra-high performance liquid chromatography coupled with tandem mass spectrometry (UHPLC–MS/MS), for the monitoring of ultra-trace levels of N-nitrosamines in water samples. Under optimized analytical conditions, chromatographic separation was performed in 3 min, in isocratic mode, using an Acquity UHPLC C18 column and a mobile phase consisting of acetonitrile, water, and formic acid (60:40:0.1, v/v/v) at a flow rate of 0.4 mL min−1. Electrospray ionization tandem interface was employed prior to mass spectrometric detection. Good linearity (R2 ≥ 0.9987) and low limits of detection (0.04–0.4 ng L−1) and quantification (0.1–1.2 ng L−1) were obtained. The extraction recoveries ranged from 98 ± 1% to 100 ± 1% and the relative standard deviations were less than 1.53%. The matrix effect was between 98 ± 2 and 100 ± 1%. The obtained results clearly demonstrate that the developed method is accurate and highly sensitive for the simultaneous determination of N-nitroso-n-propylamine, N-nitrosomorpholine, N-nitrosomethylethylamine and N-nitrosodimethylamine at ultra-trace levels (ng L−1) in different types of water samples. Therefore, this method can be a useful analytical tool for future toxicological, water quality surveillance studies and for the investigation of drinking water quality. © 2016 Institution of Chemical Engineer

Enhancing the biodegradation efficiency of a emergent refractory water pollutant by a bacterial isolate through a statistical process optimization approach

“…Under these conditions the retention time of CLA was 14 minutes and the instrumental limit of quantification (LOQ) was lower than 0.05 mg L -1 . CLA concentration (expressed in mg L -1 ) was calculated using an external calibration curve, as previously described by Kadmi et al (2017). Calibration was performed in the range of 0-10 mg L -1 by the use of standard solutions with a known analyte concentration.…”

Application of Saccharomyces cerevisiae/Calcium Alginate Composite Beads for Cephalexin Antibiotic Biosorption from Aqueous Solutions

“…CPX (50 mg/L) solutions with different pH (2)(3)(4)(5)(6)(7)(8)(9)(10)(11)(12) were put in contact with 1 g of biosorbent beads. Once the favorable pH value was established, the amount of the biosorbent was varied (0.5-3 g).…”

“…Pollution of the environment by pharmaceuticals is a challenging issue [ 1 , 2 , 3 , 4 , 5 ]. In fact, the development of analytical techniques has allowed their quantification in different environmental matrices [ 6 , 7 ].…”

Urea-Assisted Synthesis of Mesoporous TiO2 Photocatalysts for the Efficient Removal of Clofibric Acid from Water

“…Freshly prepared standard solutions were used for this purpose. The instrumental limit of detection for clofibric acid was estimated according to the procedure described by Kadmi et al [33].…”