Measurement and Prediction of Thermal Conductivity of Cement Paste

Hochstein, Daniel; Meyer, Christian

doi:10.14359/51688643

Cited by 5 publications

(1 citation statement)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Finally, two different PCMs were used inside the same energy pile along the symmetry lines, which showed an average enhancement of 9%. 3.5: Flow rate and PCM effect on the storage capacity and storage efficiency of both models .......... Table 4.1: Domain properties [97]- [100], [118], [119] 5.1: Domains thermal properties [97], [123], [124]…”

mentioning

confidence: 99%

Underground Energy Storage Utilizing Building Concrete Foundation with PCMs: Experimental and Numerical Approach

Mousa

2024

Preprint

View full text Add to dashboard Cite

<p>Geothermal energy utilization has increased 90 times since 1995 [1], ground source heat pump (GSHP) has the largest share of this value in a way to reduce the burning of fossil fuels and contributing to the reduction of greenhouse gases (GHG) emissions. Space requirement and the high initial cost of borehole field hinder the widespread of GSHP. Building foundation piles as a GHE has been presented to eliminate these limitations. However, the foundation piles have a lower depth and small spacing compared to the borehole. To increase the storage capacity and to decrease the thermal radius of energy piles, phase change material (PCM) has been presented as a potential solution. In the current study, laboratory-scale energy piles were built with and without PCM, along with a 3-D finite element model. The numerical predictions were validated with the experimental measurements, allowing the investigations of more parameters numerically. The experimental and numerical results showed that PCM increased the storage capacity and decreased the temperature distribution of the lab-scaled pile. The validated model was then modified to study the effect of latent heat and melting temperature numerically. Increasing PCM latent heat increased the models’ storage capacity and decreased their temperature distribution. The validated numerical model was then scaled up to simulate an actual energy pile with a depth of 25 m and a diameter of 1.5 m. The pile’s performance was investigated with an actual building load for a complete year. While the actual heat pump performance curve was integrated into the numerical model. PCM enhanced the heat pump coefficient of performance (COP) by up to 5.2% during the melting of PCM, while its low thermal conductivity decreased the COP by up to 1.8% during the complete solid state. PCM cylinders’ location was also investigated at 6 different locations. In addition, two PCM melting temperature ranges were investigated in order to determine the effect of PCM melting range, the results showed that PCM with a melting temperature range of (4-6)°C is better than a melting range of (1-3)°C for the current study load. Finally, two different PCMs were used inside the same energy pile along the symmetry lines, which showed an average enhancement of 9%.</p>

show abstract

mentioning

confidence: 99%