Maximum achievable aspect ratio in deep reactive ion etching of silicon due to aspect ratio dependent transport and the microloading effect

Abstract

When etching high-aspect-ratio silicon features using deep reactive ion etching ͑DRIE͒, researchers find that there is a maximum achievable aspect ratio, which we define as the critical aspect ratio, of an etched silicon trench using a DRIE process. At this critical aspect ratio, the apparent etch rate ͑defined as the total depth etched divided by the total elapsed time͒ no longer monotonically decreases as the aspect ratio increases, but abruptly drops to zero. In this paper, we propose a theoretical model to predict the critical aspect ratio and reveal its causal mechanism. The model considers aspect ratio dependent transport mechanisms specific to each of the reactant species in the three subprocesses of a time-multiplexed etch cycle: deposition of a fluorocarbon passivation layer, etching of the fluorocarbon polymer at the bottom of the trench, and the subsequent etching of the underlying silicon. The model predicts that the critical aspect ratio is defined by the aspect ratio at which the polymer etch rate equals the product of the deposition rate and the set time ratio between the deposition and etching phases for the time-multiplexed process. Several DRIE experiments were performed to qualitatively validate the model. Both model simulations and experimental results demonstrate that the magnitude of the critical aspect ratio primarily depends on ͑i͒ the relative flux of neutral species at the trench opening, i.e., the microloading effect, and ͑ii͒ aspect ratio dependent transport of ions during the polymer etching subprocess of a DRIE cycle.

Review of amorphous silicon based particle detectors: the quest for single particle detection

“…According to the model developed by Eberhardt [103], we could expect the gain values of AMCPs to increase by a factor of 10 2 -10 3 for an aspect ratio of 30, a value which is achievable with DRIE of Si [104]. From the modelling of the present AMCP, a secondary electron yield -the number of electrons generated per collision -of 1.5-1.7 was inferred.…”

X-ray waveguide optics

“…This notably applies for channels with d < 1 µm, since they are proportionally more affected by shrinking or even blocking of the channels' interior during the heating step of fabrication. Furthermore, channels of small widths d are shallower than wider ones [see red triangles in (i)] [59,60] scaling up the sensitivity to channel closing. The correspondence between the channel depth h and width d is particularly important for these small sized channels.…”

Fabrication and Operation of Acoustofluidic Devices Supporting Bulk Acoustic Standing Waves for Sheathless Focusing of Particles

“…Load the photo-patterned Si wafer into the chamber of a deep reactive ion etching instrument and etch the fluidic channels into the Si wafer to the desired depth following standard etching procedures. 22 2. Carefully unload the sample from the chamber after the etching process is complete.…”