Mathematical modelling of particle aggregation and sedimentation in the inclined tubes

Abstract

Sedimentation of the aggregating particles in the gravity field is widely used as an easy and cheap test of the suspension stability of different technical suspensions, blood and nanofluids. It was established the tube inclination makes the test much faster that is known as the Boycott effect. The dependence of the sedimentation rate on the angle of inclination is complex and poorly understood yet. In this paper the two phase model of the aggregating particles is generalized to the inclined tubes. The problem is formulated in the two-dimensional case that corresponds to the narrow rectangle vessels or gaps of the viscosimeters of the cone-cone type. In the suggestion of small angles of inclination the equations are averaged over the transverse coordinate and the obtained hyperbolic system of equations is solved by the method of characteristics. Numerical computations revealed the increase in the initial concentration of the particles, their aggregation rate, external uniform force and inclination angle accelerate the sedimentation while any increase in the fluid viscosity decelerates it that is physically relevant. Anyway, the behaviors of the acceleration are different. Based on the results, a novel method of estimation of the suspension stability is proposed.

Study on the effect of container tilt on the falling speed of suspended particles in gravity field

“…A comparison of the relationship between the sink time of particles sliding down from the highest place and the sink time of the previous kind shows that: a single particle falls vertically faster than the slope (𝐻 𝐻 𝑠𝑖𝑛 𝜃Ideally) Figure 1. Individual particle drop and container area division [10] .…”