Mathematical modelling and digital control for power supplies of current pulsed for welding machine

Vieira, Paula K. P.; Pinto, J.A.C.; Bolhosa, D.M.; Pereira, A.C.

doi:10.1109/epe.2005.219457

Cited by 2 publications

(1 citation statement)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The reverse recovery time of the diode D8 is particularly important because during the turn-on transient, current will flow from D7 into the output inductor L1, and also into the cathode of D8 during it reverse recovery period. This will reflect through to the primary switches as a current overshoot during the turn-on transient [8].…”

Section: Performancementioning

confidence: 99%

Arc Welding Machine with Half-Bridge Forward Converter

Birbir¹

2017

IJEEE

View full text Add to dashboard Cite

This paper presents a 3kW welding machine based on a half-bridge forward converter. It is known as the two transistor forward converter and has a primary power switch arrangement that is similar to its counterpart in the fly-back converter. This arrangement is particularly suitable for MOSFET transistor operation, as the energy recovery diodes D5 and D6 provide hard clamping of the switching devices to the supply line, preventing any overshoot during the fly-back operation. The voltage across the power switches will not exceed the supply voltage by more than two diode drops, and therefore voltage stress will be only half of what it would have been in the singletransistor, single-ended converter. In this system, the welding machine has been designed for one phase line input. This converter drives high frequency transformers with output ratings of 24V and 120A during welding process. The converter uses current mode PWM controller integrated circuit. SG1844 improves on the 100 KHz switching frequency with respect to size and weight, but the switching frequency is limited by the switch devices and transformer material. This control technique is able to ensure proper ignition with 78 V. The essential requirement for this welding machine power supply is to control the PWM wave form and adapt it for welding process. Current mode PWM controller can be achieved by using small values of the inductor and capacitor. The size and weight will be greatly reduced. They are reliable and flexible, offer good efficiency, fast response and control robustness. The unique load characteristics associated with arc plasma loads make this type of current mode PWM controlled converter well suited for arc striking. It also allows safe operation during the arc plasma state. The aim of this work was to design and build suitable power supply for a welding machine. This can be achieved by current mode switching power supply with a minimum number of external components.

show abstract

Section: Performancementioning

confidence: 99%