Material selection for optimum design of MEMS pressure sensors

Abstract

Choice of the most suitable material out of the universe of engineering materials available to the designers is a complex task. It often requires a compromise, involving conflicts between different design objectives. Materials selection for optimum design of a Micro-Electro-Mechanical-Systems (MEMS) pressure sensor is one such case. For optimum performance, simultaneous maximization of deflection of a MEMS pressure sensor diaphragm and maximization of its resonance frequency are two key but totally conflicting requirements. Another limitation in material selection of MEMS/ Microsystems is the lack of availability of data containing accurate micro-scale properties of MEMS materials. This paper therefore, presents a material selection case study addressing these two challenges in optimum design of MEMS pressure sensors, individually as well as simultaneously, using Ashby's method. First, data pertaining to micro-scale properties of MEMS materials has been consolidated and then the Performance and Material Indices that address the MEMS pressure sensor's conflicting design requirements are formulated. Subsequently, by using the micro-scale materials properties data, candidate materials for optimum performance of MEMS pressure sensors have been determined. Manufacturability of pressure sensor diaphragm using the candidate materials, pointed out by this study, has been discussed with reference to the reported devices. Supported by the previous literature, our analysis re-emphasizes that silicon with 110 crystal orientation [Si (110)], which has been extensively used in a number of micro-scale devices and applications, is also a promising material for MEMS pressure sensor diaphragm. This paper hence identifies an unexplored opportunity to use Si (110) diaphragm to improve the performance of diaphragm based MEMS pressure sensors.

Structural Engineering in Piezoresistive Micropressure Sensors: A Focused Review

“…Along with using new materials in the development of MEMS sensors, sensing diaphragms based on other materials are also built to fulfill emerging requirements for urgent applications, such as silicon carbide (SiC) for ultrahigh temperature sensors, advanced carbons for ultra-thin diaphragms, and polymers for new technology verification [ 66 , 67 , 68 , 69 , 70 , 71 , 72 , 73 , 74 ].…”

MEMS Technology for Early Stage Diesis Detection Using Micro-Cantilever Structure in Support of Biomedical Applications

“…In the year 2021, Mouro, J. et al explain about the dynamic responses of the microcantilever and further possibilities of modifications (1).Junyuan Zhao et alhas been implemented protein biomarkers by using gold nanoparticles in the same year(2). Kim,W.et alhas find the facts of motion detection using microcantilevers during 2020,it was based on knife edge (3).Zahid Mehmood(2020) (11).M.Mohammadi(2019) et al contributed the principles of vibrational analysis and its applications (12).H.Chen(2018) et aldone the research on CMOS -MEMS inductors (17). P.G.…”

Improved Sensitivity of MEMS-based Piezoresistive Pressure Sensor using Silicon Nitride Diaphragm

“…The material selection for specific sensor applications depends on their properties like strength, corrosion resistance, and stiffness, suitable for specific operating conditions. Ashby's method was highlighted to describe the material selection process for the optimum design of MEMS pressure sensors [19]. The particulate matter (PM) concentration is a main metric for measuring the quality of air, considering its importance, adverse effects are noticed on human health, visibility, and also in climatic change.…”