<title>Brazing copper to dispersion-strengthened copper</title>

Abstract

The wbmitted manuscript has been authored by a contractor of the U. S. Government under contrwt No. W-31-104ENG-38. Accordingly, the U. S Government retains a nonexclusive. royalty-free license to publish or reproduce the published form of this contribution, or allow others to do so, forThe Advanced Photon Source (APS) is a state-of-the-art synchrotron light source that will produce intense x-ray beams, which will allow the study of smaller samples and faster reactions and processes at a greater level of detail than has been possible to date. The beam is produced by using third-generation insertion devices in a 7-GeV (7 billion electron volts) electron/positron storage ring that is 1,104 meters (2/3 mile) in circumference. The heat load from these intense high-power devices is very high, and certain components must sustain total heat loads of 3 to 15 kW and heat fluxes of 30 W/mm2. Because the beams will cycle on and off many times, thermal shock and fatigue will be a problem. High heat flux impinging on a small area causes a large thermal gradient that results in high stress. GlidCop@, a dispersionstrengthened copper, is the desired design material because of its high thermal conductivity and superior mechanical properties as compared to copper and its alloys. GlidCop is not amenable to joining by fusion welding, and brazing requires diligence because of high diffusivity. Brazing procedures were developed using optical and scanning electron microscopy.