Long-term plasma exposure of ITER-like W/Cu monoblocks with pre-damaged surfaces in EAST experiments

Abstract

In the ITER and future fusion devices, W/Cu monoblocks will be used as divertor target which are exposed to both steady state heat load and transient heat flux. Especially, the transient heat flux up to 10 GW/m2 during plasma disruption, is expected to induce the shallow surface damages, such as melting, and even boiling of W/Cu monoblocks. Thus, the performance of damaged W/Cu monoblocks under subsequent long-term plasma discharges is a key concern that needs to be verified and tested on existing tokamaks. Since 2022, a new type of main limiter composed of ITER-like W/Cu monoblocks has been installed and tested in EAST. The surface of W/Cu monoblocks of the limiter was damaged by the transient heat flux during the early stages of plasma construction. Subsequently, they were subjected to long-term plasma discharges over 2600 shots in normal plasma discharge conditions. This circumstance conveniently facilitates the discussion of the performance of W/Cu monoblocks with damaged surfaces especially a melting edge with hill structure under prolonged exposure to plasma. In general, the shallow damage resulting from transient heat flux on W/Cu monoblocks appears to have minimal impact on the heat exhaust capacity under steady-state heat loads, as indicated by both experimental monitoring and numerical simulation results. However, shallow melting, leading to a change in surface structure and the formation of hills, could theoretically increase local temperatures, creating potential hot spots. This phenomenon requires further validation through dedicated experiments. Moreover, the brittleness of the near-surface layer may give rise to brittle destructions, such as cracks and even dust particles, posing an additional concern. These findings yield unique qualitative conclusions that can be referenced for ITER and other fusion devices.

The effect of the electron κ-distribution on the dust particle charging in the radio-frequency thermal-sheaths

“…However, the construction materials utilized in regulated fusion equipment are subject to a variety of alterations resulting from plasma-wall interaction processes, such as material erosion and redeposition. In some instances, eroded material is transformed into dust particles of diverse compositions and sizes [1][2][3][4][5]. Dust generation is a significant challenge.…”