Locomotive Crash Energy Management Coupling Tests

Abstract

Research to develop new technologies for increasing the safety of passengers and crew in rail equipment is being directed by the Federal Railroad Administration's (FRA's) Office of Research, Development, and Technology. Crash energy management (CEM) components which can be integrated into the end structure of a locomotive have been developed: a pushback coupler and a deformable anti-climber. These components are designed to inhibit override in the event of a collision. The results of vehicle-to-vehicle override, where the strong underframe of one vehicle, typically a locomotive, impacts the weaker superstructure of the other vehicle, can be devastating. These components are designed to improve crashworthiness for equipped locomotives in a wide range of potential collisions, including collisions with conventional locomotives, conventional cab cars, and freight equipment.Concerns have been raised in discussions with industry that push-back couplers may trigger prematurely, and may require replacement due to unintentional activation as a result of service loads. Push-back couplers are designed with trigger loads meant to exceed the expected maximum service loads experienced by conventional couplers. Analytical models are typically used to determine these required trigger loads. Two sets of coupling tests are planned to demonstrate this, one with a conventional locomotive equipped with conventional draft gear and coupler, and another with a conventional locomotive retrofit with a pushback coupler. These tests will allow a performance comparison of a conventional locomotive with a CEM-equipped locomotive during coupling. In addition to the two sets of coupling tests, carto-car compatibility tests of CEM-equipped locomotives, as well as a train-to-train test are also planned. This arrangement of tests allows for evaluation of the CEM-equipped locomotive performance, as well as comparison of measured with simulated locomotive performance in the car-to-car and train-to-train tests.The coupling tests of a conventional locomotive have been conducted, the results of which compared favorably with pre-test predictions. In the coupling tests of a CEM-equipped locomotive, the coupling speed for which the push-back coupler (PBC) triggers will be measured. A moving, CEM-equipped locomotive will be coupled to a standing cab car. The coupling speed for the first test will be low, approximately 2 mph. The test will then be repeated with the speed increasing incrementally until the PBC triggers. This paper describes the fabrication, retrofit, test requirements, and analysis predictions for the CEM coupling tests. The equipment to be tested, track conditions, test procedures, and measurements to be made are described. A model for predicting the longitudinal forces acting on the equipment and couplers has been developed, along with preliminary predictions for the CEM coupling tests. BACKGROUNDThe Office of Research, Development, and Technology of the Federal Railroad Administration (FRA) and the Volpe Center are continuing to ...