Liquid-phase boriding of high-chromium steel

Abstract

Using the methods of modern physical materials science, structuralphase states and tribological properties of 12Kh18N10T steel, subjected to electroexplosive alloying with titanium and boron and subsequent electron-beam processing in various modes depending on electron beam energy density, exposure pulse duration and their quantity have been analyzed. It has been established that electroexplosive alloying of steel with titanium and boron leads to formation of surface layer with multiphase submicro-nanocrystalline structure, characterized by presence of micropores, microcracks, and microcraters. Complex processing, combining electroexplosive alloying and subsequent irradiation with high-intensity pulsed electron beam, leads to formation of 60 μm thick multiphase submicro-nanocrystalline surface layer. It is shown that phase composition of surface layer of steel is determined by mass ratio of titanium and boron during electroexplosive alloying. Microhardness of modified layer is defined by relative mass fraction of titanium borides in surface layer and can be more than 18 times higher than microhardness of steel in its initial state (before electroexplosive alloying). Modes of complex processing have been determined at which surface layer containing exclusively titanium borides and intermetallic compounds based on titanium and iron is formed. The maximum (approximately 82 % by weight) titanium boride content is observed when steel is processed at regime with the highest mass of boron powder in the sample (mB = 87.5 mg; mTi /mB = 5.202). With decrease in mass of boron powder, relative content of borides in surface layer of steel decreases. It was found that integrated processing of steel is accompanied by sevenfold increase in microhardness of surface layer, wear resistance of steel increases by more than nine times.