Libs Hydrogen Isotopes Detection: Significance in Nuclear/Fusion Technology

Trtica, M.; Savovic, J.; Kuzmanovic, M.; Rankovic, D.; Stasic, J.

doi:10.1007/s10812-024-01669-0

Cited by 2 publications

(2 citation statements)

References 32 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Moreover, Trtica et al 70 extensively reviewed the utilization of LIF-LIBS for detecting hydrogen isotopes within nuclear materials, emphasizing the principles, advantages, limitations, and specific methodologies applied in nuclear fusion and fission reactor materials.…”

Section: Case Studiesmentioning

confidence: 99%

In situ online detection of atmospheric particulate matter based on laser induced breakdown spectroscopy: a review

Sun,

Yu,

Feng

et al. 2024

J. Anal. At. Spectrom.

View full text Add to dashboard Cite

show abstract

Section: Case Studiesmentioning

confidence: 99%

In situ online detection of atmospheric particulate matter based on laser induced breakdown spectroscopy: a review

Sun,

Yu,

Feng

et al. 2024

J. Anal. At. Spectrom.

View full text Add to dashboard Cite

show abstract

“…Nuclear fusion is a non-polluting physical reaction in which two light nuclei unite to form a heavier nucleus and a lighter particle. The reaction results in energy release by the two nuclei, which is distributed among the products in a way that is inversely proportional to their masses, as derived by the conservation of momentum and energy [1,2]. In particular, for the deuterium and tritium fusion reaction, helium and highly energetic neutrons are released, with energies of ~3.5 MeV and ~14 MeV, respectively.…”

Section: Introductionmentioning

confidence: 99%

The Influence of Crystal Orientation and Thermal State of a Pure Cu on the Formation of Helium Blisters

Shtuckmeyster,

Maman,

Vaknin

et al. 2024

Metals

View full text Add to dashboard Cite

The factors that influence the formation of helium blisters in copper were studied, including crystallographic grain orientation and thermomechanical conditions. Helium implantation experiments were conducted at 40 KeV with a dose of 5 × 1017 ions/cm2, and the samples were then subjected to post-implantation heat treatments at 450 °C for different holding times. A scanning electron microscope (SEM) equipped with an electron backscatter diffraction (EBSD) detector was used to analyze the samples, revealing that the degree of blistering erosion and its evolution with time varied with the crystallographic plane of the free surface in different ways in annealed and cold rolled copper. Out of the investigated states, rolled copper with a (111) free surface had superior helium blistering durability. This is explained by the consideration of the multivariable situation, including the role of dislocations and vacancies. For future plasma-facing component (PFC) candidate material, similar research should be conducted in order to find the optimal combination of material properties for helium blistering durability. In the case of Cu selection as a PFC, the two practical approaches to obtain the preferred (111) orientation are cold rolling and thin layer technologies.

show abstract

Libs Hydrogen Isotopes Detection: Significance in Nuclear/Fusion Technology

Cited by 2 publications

References 32 publications

In situ online detection of atmospheric particulate matter based on laser induced breakdown spectroscopy: a review

In situ online detection of atmospheric particulate matter based on laser induced breakdown spectroscopy: a review

The Influence of Crystal Orientation and Thermal State of a Pure Cu on the Formation of Helium Blisters

Contact Info

Product

Resources

About