Isotope ratio analysis of actinides, fission products, and geolocators by high-efficiency multi-collector thermal ionization mass spectrometry

Bürger, Stefan; Riciputi, Lee R.; Bostick, D.T.; Turgeon, Steven; McBay, Eddy H.; Lavelle, Mark

doi:10.1016/j.ijms.2009.06.010

Cited by 68 publications

(66 citation statements)

References 166 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Very briefly, when a certain heating pattern is followed, uranium ion formation efficiency as measured on the mass resolved detector of the mass spectrometer averaged 2%. This compares to a reported average in the range of 0.5% for resin beads 4 . This factor of four is significant in itself, but an even more important advantage for a high value sample is that 25% of the samples may be lost with resin beads and this loss drops to zero for PIEs.…”

Section: Uranium Analysiscontrasting

confidence: 55%

Micro Ion Source Program NA22 Plutonium Detection Portfolio Final Report

Delmore¹

2010

View full text Add to dashboard Cite

Under DOE Idaho Operations Office Contract DE-AC07-05ID14517 iv SUMMARYThe purpose of the micro ion source program was to enhance the performance of thermal ionization mass spectrometry (TIMS) for various actinides and fission products. The proposal hypothesized that when ions are created at the ion optic center of the mass spectrometer, ion transmission is significantly increased and the resulting ion beam is more sharply focused. Computer modeling demonstrated this logic. In order to prove this hypothesis it was first necessary to understand the chemistry and physics governing the particular ion production process that concentrates the emission of ions into a small area. This has been achieved for uranium and technetium, as was shown in the original proposal and the improvement of both the beam transmission and sharpness of focus were proven. Significantly improved analytical methods have been developed for these two elements based upon this research. The iodine portion of the proposal turned out to be impractical due to volatility of iodine and its compounds. We knew this was a possibility prior to research and we proceeded anyway but did not succeed. Plutonium is a potential option, but is not quite up to the performance level of resin beads. Now, we more clearly understand the chemical and physical issues for plutonium, but have not yet translated this knowledge into improved analytical processes. The problems are that plutonium is considerably more difficult to convert to the required intermediate species, plutonium carbide, and the chemical method we developed that works with uranium functions only moderately well with plutonium. We are of the opinion that, with this knowledge, similar progress can be made with plutonium.The breakthrough with uranium has come from development of what has been named the micro porous ion emitter (PIE). Many iterations of PIEs were developed and tested prior to settling on a particular formula. This formula is a 50/50 blend of rhenium and platinum powders initially held together with melted hot glue and extruded into a very small diameter rope. This rope is sliced into very thin pieces that are positioned in the exact center of a rhenium mass spectrometer filament. The filament is then heated in a vacuum to first evaporate the hot glue and then to melt the platinum to alloy with the rhenium powder and filament. This mixture/formula results in a highly porous micro structure consisting of the rhenium/platinum alloy bonded to the rhenium filament. A water soluble ion exchange resin is wicked into the PIE and dried. The sample is then wicked into the PIE so that the element can absorbed onto the resin. The solution is allowed to sit in the PIE long enough for the element to absorb onto the ion exchange sites of the resin and then dried. The sample is then ready for analysis.Three articles will be published in the International Journal of Mass Spectrometry; one is published, the second is accepted and the third has been submitted and is in review. The first appeared in the Septe...

show abstract

Section: Uranium Analysiscontrasting

confidence: 55%

Micro Ion Source Program NA22 Plutonium Detection Portfolio Final Report

Delmore¹

2010

View full text Add to dashboard Cite

show abstract

“…The increasing threat of nuclear weapons development has prompted the use of a number of mass spectrometry techniques charged with the task of determining the isotopic composition of trace amounts of radionuclides from a diverse set of materials [1][2][3][4][5][6][7]. A major focus for these types of measurements is on improving the sensitivity for the detection of uranium and transuranic isotopes in the presence of isobaric interferences without the need for complex and time-consuming sample preparation methods.…”

Section: Introductionmentioning

confidence: 99%

RIMS analysis of ion induced fragmentation of molecules sputtered from an enriched U3O8 matrix

Willingham

Savina

Knight

et al. 2012

J Radioanal Nucl Chem

View full text Add to dashboard Cite

“…Additionally, TIMS has profited from significant instrumental improvements on the detection side. For instance, the multiple ion counting (MIC) systems enabled to lower the minimum sample amounts required from the micro-to the low picogram range for both uranium and plutonium [8][9][10][11][12][13][14][15]. However, the ionization efficiency of uranium (ratio of atoms ionized to sample atoms loaded on a filament) is relatively poor in a TIMS source.…”

Section: Introductionmentioning

confidence: 99%