Investigation on high-velocity impact performance of multi-layered alumina ceramic armors with polymeric interlayers

Abstract

In this study, ballistic behavior of multi-layered ceramic armors under high velocity impact is studied numerically. The model consists of 2D-axisymmetric Lagrangian approach with Johnson–Holmquist constitutive model for alumina ceramic tiles, Mie–Gruneisen equation of state for polymeric interlayers, and Johnson–Cook constitutive relation for Armor Piercing (AP) projectile. The finite element results obtained from various armor layups show the potentiality of multi-layered ceramic armor in extending conoid fracture through the ceramic layers, thus leading to the increase in the armor performance. It is illustrated that besides ceramic armor layup, interlayers of ceramic tiles have a significant role in increasing the armor performance. Finally, the effect of different polymeric interlayers on ballistic performance of multi-layered ceramic armors against AP projectile is investigated. In order to measure the ballistic performance of the armors, various criteria are introduced. Depth of penetration of the projectile in the armor, residual velocity of the projectile, time duration in which the projectile is engaged inside the armor, projectile tip erosion during impact, and interaction volume ratio are some of these criteria. The study indicates that armor layup with thin front ceramic tiles backed by thicker tiles shows better conoid fracture extension and often better ballistic performance. Furthermore, among the polymeric interlayers used between the ceramic tiles, polystyrene causes the best and nylon causes the worst ballistic performance in the armor.

Karakteristik Fiber Metal Laminate Akibat Beban Impak Balistik Dari Peluru Kaliber 9 mm Full Metal Jacket (FMJ)

“…Pemodelan untuk material elastis dan plastis digunakan dalam simulasi. Model material elastis dianggap linear dan dipengaruhi oleh modulus elastis dan poisson ratio sedangkan model material plastis dan kriteria kegagalan material yang digunakan dalam simulasi menggunakan model Johnson-Cook untuk material logam [12]. Peluru dan plat aluminium menggunakan model plastisitas Johnson-Cook seperti pada persamaan 1.…”

The investigation into vibration effect on microstructure and mechanical characteristics of friction stir spot vibration welded aluminum: Simulation and experiment

“…In equation (2), θ, θ melt , and θ transition indicate the instantaneous temperature, melting point, and the transfer temperature, respectively. The Johnson–Cook parameters used for AA5083, based on literature, 22 are shown in Table 4.…”

A model incorporating damage evolution to predict the penetration behavior of a ceramic target subjected to the long projectile impact

“…where E is the initial elastic modulus and ν is the Poisson's ratio. (12) With the consideration of stress continuity at the elastic/cracked region boundary, combining Eq. (9) and Eq.…”

“…Numerous research activities have been performed in the past decades to investigate the correlation between material properties of ceramics and their dynamic response including the ballistic performance in high strain rate conditions [7][8][9][10][11][12][13][14][15][16]. The dynamic behaviour of ceramic materials is significantly affected by their properties such as hardness, elastic modulus, fracture toughness and failure probability [10,[17][18][19][20][21][22][23][24].…”