Investigation on Coal Skeleton Deformation in CO2 Injection Enhanced CH4 Drainage From Underground Coal Seam

Abstract

To reveal the evolution law of coal skeleton deformation during the process of CO2 flooding and displacing CH4 in coal seam, a fluid-solid coupling mathematical model of CO2 injection enhanced CH4 drainage was established based on Fick’s law, Darcy’s law, ideal gas state equation, and Langmuir equation. Meanwhile, numerical simulations were carried out by implementing the mathematical model in the COMSOL Multiphysics. Results show that the CH4 content of both regular gas drainage and CO2 enhanced gas drainage gradually decreases with time, and the decreasing rate is high between 10 and 60 days. Compared with regular gas drainage, the efficiency of CO2 enhanced gas drainage is more obvious with greater amount of CH4 extracted out. When coal seam gas is extracted for 10, 60, 120, and 180 days, CH4 content in coal seam is reduced by 5.2, 17.2, 23.6, and 26.7%, respectively. For regular gas drainage, the deformation of coal skeleton is dominated by the shrink of coal matrix induced by gas desorption, and the strain curve shows a continuous downward trend. For CO2 enhanced gas drainage, the strain curve of coal skeleton showed a decrease—rapid increase—slow increase trend. The evolution of permeability is opposite to the evolution of coal skeleton strain. Higher gas injection pressure will lead to a greater coal skeleton strain. The pumping pressure affects the deformation of coal skeleton slightly compared with that of initial water saturation and initial temperature. Greater initial water saturation leads to larger deformation of coal skeleton in the early stage. The strain value of coal skeleton gradually tends to be consistent as gas injection prolongs. Higher initial temperature leads to greater reduction in coal skeleton strain when the gas injection continues. Research achievements provide a basis for the field application of CO2 injection enhanced CH4 drainage in underground coal mines.

Influence of Various Control Factors on Fracture Toughness and Fracture Energy of Sandstone Subjected to Liquid Nitrogen Cooling

“…The mechanical properties and fracture energy of rocks can be reflected from the failure mode to some extent. − Therefore, the relationship between the crack morphology and the fracture characteristics is discussed. Figure shows the failure modes of the sandstone samples under different conditions.…”

Instability and failure characteristics of surrounding rock of water drenching roadway in thick coal seam

“…Recently, Li and He (He, 2014;Li et al, 2016;Fan et al, 2021) proposed that the deformation of the surrounding rock is caused by various factors such as soft features, poor support, high ground stress, groundwater, and geological formations. The research on the surrounding rock control technology of water drenching and soft rock roadways is mainly carried out through numerical simulation, industrial tests, and laboratory tests (Zhang et al, 2016;Tao et al, 2020;Zhai et al, 2022).…”

Synergistic Stabilization Mechanism of SiO2 Nanoparticles and Anionic Surfactants during Foam Fracturing

“…Coalbed methane (CBM), a hydrocarbon gas resource stored in coal seams, is an attractive alternative to traditional energy sources, such as coal. , China ranks third in the world in CBM reserves. − CBM is an unconventional natural gas resource that consists primarily of methane . The development and utilization of CBM relieve the gas pressure in coal seams, thereby improving the safety of coal mine production. , However, most gas reservoirs present low permeability and shortcomings, such as low porosity and high ground pressure; therefore, stimulation measures should be implemented to increase the drainage rate. − Hydraulic fracturing is a common technology used to increase CBM production .…”