Investigation of Voltage Imbalance Due to Distribution Network Unbalanced Line Configurations and Load Levels

Abstract

In distribution power systems line transposition is not a common practice and phase loading levels are always changing. Therefore, perfect balance is never achieved at a distribution level. Non-transposed lines can cause unequal voltage drops between phases and this may be further exacerbated by uneven loads in each phase. Consequently, the voltage magnitude of a certain phase may suffer a severe decrease, breaching the lower voltage limit or unbalanced three-phase voltages at a remote bus may violate the percentage voltage imbalance accepted in the standards. This paper examines the mechanism of causing uneven voltage drops and investigates the impacts of unbalanced line configurations with different phase loading levels on network voltage imbalance. Methodologies are proposed to analyze voltage drops affected by line and load imbalance. Based on these methods, general guidelines are recommended to mitigate the voltage problems, which are useful for network analysis, planning and reconfiguration.

Methodology for the analysis of voltage unbalance in networks with single‐phase distributed generation

“…Based on the analysis above, it can be concluded that the magnitude of 1 and should be close, thus sign '+' is selected in (10). Then, the magnitude of voltage ′ can be derived based on (8) and (10) as below:…”

Analysis of the Influence of Asymmetric Grid on Synchronous Hydro Generator

“…So, the main factor that leads to the asymmetrical operation of the synchronous hydro generator is the asymmetry of three-phase current [1]. In real life, the existence of asymmetrical load, such as the electric locomotive in transportation, the electric furnace in metallurgical factory and the asymmetrical impedance of three-phase lines, leads to the generation of asymmetrical current in power grid [2][3][4][5][6][7]. Since the synchronous hydro generator is directly connected to the grid through the transformer, the influence of asymmetrical three-phase current on the generator is inevitable.…”

Voltage and current balancing in Low and Medium Voltage grid by means of Smart Transformer

“…Investigating the voltage unbalance level during a long period, many violations of the limit imposed by the [3] have been found, mostly if the BEVs charging is not coordinated by any control algorithm. A detailed assessment on the impact of asymmetrical line geometry and unbalanced load on the voltage profiles is developed in [6]: it proposes a new load transposition method for mitigating the voltage unbalance. As explained in [7]- [9], the unbalanced voltage conditions impacts heavily on the motors (heating increase, torque pulsation, and reduction of lifespan).…”