Investigation of Residual Stresses Induced by Incremental Sheet Forming and Stamping in Aluminum Alloys

Kumar, Dharmesh; Liu, Zhigang; Jirathearanat, Suwat; Kumar, Abhishek

doi:10.1007/s11665-022-07304-3

Cited by 2 publications

(1 citation statement)

References 25 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…This is because the constraining conditions of the metal sheet during the forming process are altered by changes in the stamping process parameters, dispersing the surface stress. 20,21 Thus, springback is reduced in the optimized V-shaped clamp.…”

Section: Resultsmentioning

confidence: 99%

Influence and improvement of stamping process parameters on V-shaped clamp forming quality

Hu,

Qiu,

Mei

et al. 2024

Advances in Mechanical Engineering

View full text Add to dashboard Cite

Aiming at the problems that a V-shaped clamp is easy to crack, wrinkle, and springback in the stamping process, a method to improve forming quality by setting the best stamping process parameters is put forward in this paper. The stamping process of the V-shaped clamp was simulated by using the software of ABAQUS, which showed that the stamping process parameters, such as friction coefficient, stamping speed, and mold gap, can affect the forming quality. The optimal combination of stamping process parameters was obtained through an orthogonal experiment. Simulation, profile dimensional measurement, and Fuji paper test were conducted to evaluate and examine the quality of V-shaped clamps before and after optimization. According to the findings of the study, the stamping speed is the main factor affecting the simulation results. The comprehensive effect of the maximum thinning rate, maximum thickening rate, and maximum springback is the best with the stamping speed of 10.00 mm·s−1. The ideal specifications for the stamping process are a 0.16 friction coefficient, a 10.00mm·s−1 stamping speed, and a 2.20 mm mold gap. Process parameter modification can greatly increase the dimensional accuracy and mechanical properties of molded parts.

show abstract

Section: Resultsmentioning

confidence: 99%