Investigation of machinability properties of AISI H11 tool steel for sustainable manufacturing

Abstract

In this experimental study, vibration, energy consumption, power consumption and surface roughness values that occur in the machining of AISI H11 tool steel under CO2, coolant and dry cutting conditions were investigated. The effects of different cutting parameters and cooling systems on machinability were investigated. Analysis of variance was done. Regression equations were obtained. Relationships between power consumption, vibration and surface roughness are explained with mathematical equations. Finally, the optimum CC were determined by the multiple optimization methods. According to the test results, while the instantaneous power consumption increases by increasing cutting parameters, energy consumption decreases as the processing time is shortened. Vibration value increases by increasing cutting parameters. The highest vibration value occurs in cutting with CO2. Compared to dry and CO2 cutting, the vibration is lowest in coolant cutting. The friction decreases with the coolant and the vibration value decreases. There is a similar relationship between vibration and surface roughness value. The most effective parameter on the surface roughness value is the feed rate. It was seen that the most suitable CC for the most efficient cutting, the lowest energy consumption, vibration and surface roughness value, under coolant cutting, 0.2 mm depth of cut, 175 m/min cutting speed and 0.119 mm/rev feed rate. With optimum CC, the vibration value was reduced by 5.18%, the surface roughness value by 37.12%, energy consumption by 36.19% and the machine efficiency was increased by 7.16%.

A Concise Review on Materials for Injection Moulds and Their Conventional and Non-Conventional Machining Processes

“…Şahino glu [107] This author investigated the vibration, energy Increasing a p reinforces these trends. Significant differences are observed in the achievable R z and their qualitative geometry, along with anisotropies in the structure formation, concerning the surface topography.…”