Investigation of iron opacity experiment plasma gradients with synthetic data analyses

Abstract

Experiments have been performed at Sandia National Laboratories Z-facility to validate iron opacity models relevant to the solar convection/radiation zone boundary. Sample conditions were measured by mixing Mg with the Fe and using Mg K-shell line transmission spectra, assuming that the plasma was uniform. We develop a spectral model that accounts for hypothetical gradients, and compute synthetic spectra to quantitatively evaluate the plasma gradient size that can be diagnosed. Two sample designs are investigated, assuming linear temperature and density gradients. First, Mg uniformly mixed with Fe enables temperature gradients greater than 10% to be detected. The second design uses Mg mixed into one side and Al mixed into the other side of the sample in an attempt to more accurately infer the sample gradient. Both temperature and density gradients as small as a few percent can be detected with this design. Experiments have successfully recorded spectra with the second design. In future research, the spectral model will be used to place bounds on gradients that exist in Z opacity experiments.

Full-wave feasibility study of anti-radar diagnostic of magnetic field based on O-X mode conversion and oblique reflectometry imaging

“…Furthermore, the signal to noise ratio is higher, by simply adopting a sufficiently intense reflectometric source. The spatial and temporal resolution are comparable with other reflectometric imaging systems [12][13][14] .…”

“…Full-wave simulations exhibited the expected "hole" in reflectivity for that special direction of incidence. At the frequencies analyzed in our study (10)(11)(12)(13)(14)(15)(16)(17)(18)(19)(20), simulations show also that this reflectivity hole is complicated by reflections at the X-mode cutoff layer, which is itself a function of the the angle of incidence.…”

Enigmatic photon absorption in plasmas near solar interior conditions

“…the Sandia experiments include supporting measurements to test the reliability of the data [2,3,17,18].…”

Control and diagnosis of temperature, density, and uniformity in x-ray heated iron/magnesium samples for opacity measurements

“…where i α j i = 1.0. By assuming the fraction α j i is determined by the initial target design 55 , one can compute emergent spectra of multi-species plasmas just by providing T e, i and n e, i at each zone i. The areal number density of each element, N j L , can either be provided by RBS measurements or extracted from the analysis.…”