Investigation of impedance and leakage feature in BFO-BTO perovskite system

Brahma, F.; Sahoo, Lutu; Bhattacharjee, Sourav; Hota, R.L.; Parida, B. N.; Parida, R.K.

doi:10.1016/j.matpr.2022.07.440

Cited by 2 publications

(1 citation statement)

References 21 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Standard impedance spectroscopy was used to investigate the electrical properties of the samples and was carefully examined in terms of interfacial/electrode, grain, grain boundary, etc. Impedance technique was used to record electrical responses at particular temperatures when a sinusoidal signal with a frequency of 1 KHz to 8 MHz was applied (Brahma et al, 2022). The change in the impedance with respect to the frequency is shown in the figure.…”

Section: Impedance Spectroscopymentioning

confidence: 99%

Investigation of Dielectric, Magnetic and Electrical Behavior of BFO/GNPs Nano-Composites Synthesized via Sol-Gel Method

et al. 2022

View full text Add to dashboard Cite

Nano composites of Ba0.5Bi0.5Nd0.05Fe0.95O3 multiferroic with graphene nano platelets (GNPs)x (x = 0, 0.125 %, 0.375 %, and 0.5 %) were synthesized using sol-gel auto ignition process. XRD analysis revealed a single rhombohedrally distorted phase of Ba0.5Bi0.5Nd0.05Fe0.95O3. The present study unfold the impact of GNPs on the structural, electrical, dielectric, and magnetic properties of Ba0.5Bi0.5Nd0.05Fe0.95O3 multiferroics. The substitution of Rare earth elements in pure BFO reduced the value of leakage current which is the basic drawback related with pure BFO. The prepared nanocomposites are then sintered at 800 °C for 7 hrs. The X-ray diffraction patterns showed the rhombohedral distorted perovskite crystal structure of the prepared samples including lattice constant, crystallite size, and X-ray density. The average crystallite sizes of the prepared nanocomposites are noticed in the range 28.14 -to 29.74 nm with increasing the GNPs concentration and lattice constant is found in the range 11.59 -to 11.61 Å. Temperature-dependent resistivity is first observed to increase with an increase in temperature then resistivity decreased with increasing the temperature which indicates a semi-conductor-like behavior as measured by two probe I-V characteristics. LCR technique showed that both the dielectric constant and the dissipation factor are decreased with an increase in frequency. VSM results indicated that saturation magnetization is noted to increase while remanent magnetization decreases with increasing concentration of GNPs.

show abstract

Section: Impedance Spectroscopymentioning

confidence: 99%