Investigation of hybrid fusion bonds under varying manufacturing and operating procedures

Lippky, Kristian; Mund, M.; Blass, David M.; Dilger, Klaus

doi:10.1016/j.compstruct.2018.01.078

Cited by 10 publications

(1 citation statement)

References 22 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The necessary process parameters for heat-assisted press joining are the joining temperatures of both joining partners and the joining force. Extensive studies have already been carried out on this [15,17].…”

Section: Heat-assisted Press Joining Of Hybrid Frp Steel Componentsmentioning

confidence: 99%

Process chain for forming and consolidating fiber-reinforced thermoplastics and metallic sheets in a two-stage isothermal tool

Behrens

Raatz

Hübner

et al. 2023

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

Due to their good mechanical properties and low structural weight, multi-material structures are a promising approach in the automotive industry to lightweight design, body construction and functionalization. Especially metal and plastic are mainly combined to achieve improved properties of the final component compared to mono-material structures. This paper describes the development of a manufacturing cell for the joint forming and heat-assisted press joining of steels and continuous fiber-reinforced thermoplastics in the form of unidirectional carbon-fiber tapes. In order to achieve shorter cycle times and to ensure economical production, a manufacturing cell, supplemented with automated handling by means of two robots and an isothermal, two forming stages tool concept was developed and tested. The composite components produced were tested with regard to their mechanical performance. The feasibility of the production was demonstrated. All composite components had a higher specific load capacity than a pure steel component. Cycle times of well under 60 seconds were achieved. An enormous reduction in process time compared to variothermal tool concepts could be achieved with the new manufacturing cell.

show abstract

Section: Heat-assisted Press Joining Of Hybrid Frp Steel Componentsmentioning

confidence: 99%

Process chain for forming and consolidating fiber-reinforced thermoplastics and metallic sheets in a two-stage isothermal tool

Behrens

Raatz

Hübner

et al. 2023

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

show abstract

Laservorbehandlung zur Haftungsverbesserung bei Metall-Faserverbund-Hybridstrukturen

Lippky

Hartwig

Dilger

2020

Zukunftstechnologien Für Den Multifunktionalen Leichtbau

View full text Add to dashboard Cite

Insert-injection moulding and post-thermal treatment of hybrid continuous and discontinuous glass-fibre-reinforced polyamide composite products

Wang,

Li,

et al. 2025

Composites Part A: Applied Science and Manufacturing

View full text Add to dashboard Cite

Investigation of hybrid fusion bonds under varying manufacturing and operating procedures

Cited by 10 publications

References 22 publications

Process chain for forming and consolidating fiber-reinforced thermoplastics and metallic sheets in a two-stage isothermal tool

Process chain for forming and consolidating fiber-reinforced thermoplastics and metallic sheets in a two-stage isothermal tool

Laservorbehandlung zur Haftungsverbesserung bei Metall-Faserverbund-Hybridstrukturen

Insert-injection moulding and post-thermal treatment of hybrid continuous and discontinuous glass-fibre-reinforced polyamide composite products

Contact Info

Product

Resources

About