Investigation of Carbon Fiber Reinforced Polymer Composite Welding with a New Tool in Friction Stir Welding Method

Golibidgoli, Mohsen; Ranjbaran, Ali; Mirzavand, K.; Shajari, Y.; Seyedraoufi, Z. S.; Porhonar, Mohammad

doi:10.5829/ije.2019.32.06c.09

Search citation statements

Order By: Relevance

Paper Sections

Select...

Fsp Tool1

Citation Types

Supporting

Mentioning

Contrasting

Year Published

2021

Publication Types

Select...

Article2

Relationship

Self Cite0

Independent2

Authors

Journals

Cited by 2 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Therefore, john's tool design is the model for the current tooling used at BYU. The FSP tool consists of two main functions: localized heating and material flow [13,14]. Figure 1 shows the schematic of the FSP tools was used in this study.…”

Section: Fsp Toolmentioning

confidence: 99%

Microstructure and mechanical properties of PA6/NBR nanocomposites fabricated by friction stir processing

Ghorbankhan

Nakhaei

2021

IJE

View full text Add to dashboard Cite

Section: Fsp Toolmentioning

confidence: 99%

Microstructure and mechanical properties of PA6/NBR nanocomposites fabricated by friction stir processing

Ghorbankhan

Nakhaei

2021

IJE

View full text Add to dashboard Cite

[Retracted] Experimental Investigation and Optimization on Friction Stir Welding of Nylon 6A Using Taguchi and ANOVA with Microstructural Analysis

Kumar

Rajesh³

et al. 2021

Advances in Materials Science and Engineering

View full text Add to dashboard Cite

Friction stir welding is an environmentally friendly process of joining due to the nonusage of flux, or any shield gas, and it does not produce any harmful gases when compared to the joining process of fusion. Therefore, this article proposes an experimental investigation and optimization technique for studying the process of FSW on nylon 6A or polycaprolactam polymer composite plates. Specifically, the influence of input operating process parameters such as tool rotational speed (TRS), feed rate, and pitch values on the output response parameters like ultimate tensile strength (UTS) and hardness of welded joints is examined. In addition, L27 orthogonal array of Taguchi approach is employed for the optimization of design experiments of FSW parameters. The experimental setup is carried out with various process parameter combinations like 500 rpm, 1000 rpm, and 1500 rpm as TRS, and 30 mm, 40 mm, and 50 mm as feed rate by varying the pitch values as 1 mm, 2 mm, and 3 mm. Further, the analysis of variance (ANOVA) is also employed for finding the significant parameters of input process using the regression analysis equations. Finally, microstructural analysis is used to assess the mixing or dispersing uniformity of composites effectively.

show abstract

Investigation of Carbon Fiber Reinforced Polymer Composite Welding with a New Tool in Friction Stir Welding Method

Cited by 2 publications

References 0 publications

Microstructure and mechanical properties of PA6/NBR nanocomposites fabricated by friction stir processing

Microstructure and mechanical properties of PA6/NBR nanocomposites fabricated by friction stir processing

[Retracted] Experimental Investigation and Optimization on Friction Stir Welding of Nylon 6A Using Taguchi and ANOVA with Microstructural Analysis

Contact Info

Product

Resources

About