Investigating the Performance of the Multi-Lobed Leaf-Shaped Oscillatory Obstacles in Micromixers Using Bulk Acoustic Waves (BAW): Mixing and Chemical Reaction

Abstract

Proper mixing in microfluidic devices has been a concern since the early development stages. Acoustic micromixers (active micromixers) attract significant attention due to their high efficiency and ease of implementation. Finding the optimal geometries, structures, and characteristics of acoustic micromixers is still a challenging issue. In this study, we considered leaf-shaped obstacle(s) having a multi-lobed structure as the oscillatory part(s) of acoustic micromixers in a Y-junction microchannel. Four different types of leaf-shaped oscillatory obstacles, including 1, 2, 3, and 4-lobed structures, were defined, and their mixing performance for two fluid streams was evaluated numerically. The geometrical parameters of the leaf-shaped obstacle(s), including the number of lobes, lobes’ length, lobes’ inside angle, and lobes’ pitch angle, were analyzed, and their optimum operational values were discovered. Additionally, the effects of the placement of oscillatory obstacles in three configurations, i.e., at the junction center, on the side walls, and both, on the mixing performance were evaluated. It was found that by increasing the number and length of lobes, the mixing efficiency improved. Furthermore, the effect of the operational parameters, such as inlet velocity, frequency, and intensity of acoustic waves, was examined on mixing efficiency. Meanwhile, the occurrence of a bimolecular reaction in the microchannel was analyzed at different reaction rates. It was proven that the reaction rate has a prominent effect at higher inlet velocities.

Rational PCR Reactor Design in Microfluidics

“…Microfluidics is one of the main paths towards faster, less expensive, POC PCR systems with a smaller footprint as it allows for the miniaturization of fluidic pathways and PCR reactor size while increasing the reactor’s surface-to-volume ratio [ 8 , 9 ]. It also reduces the amount of reagents used and lowers the sample volume required [ 10 , 11 ].…”

Review of Ultrasonic Particle Manipulation Techniques: Applications and Research Advances

“…When acoustic waves interact with the medium, two acoustic phenomena occur: acoustic streaming-induced forces and acoustic radiation forces, and one of these phenomena or a combination of them manipulates particles. Two different acoustic modes are commonly used to manipulate particles: surface acoustic wave (SAW) [ 13 ] and bulk acoustic wave (BAW) [ 14 ]. SAW is mainly generated by an interdigital transducer (IDT), where the acoustic signal propagates along the surface of a piezoelectric substrate, allowing the manipulation of tiny objects in a one- or two-dimensional plane.…”